Sanyo PLC-WXU300 RS232 Expand - Page 43
CF_PJPINCODE Command, 10.27 CF_FANMODE Command, 10.28 CF_FANCONTROL Command
UPC - 086483074226
View all Sanyo PLC-WXU300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
PLC-WXU300 Expand Serial Command Functional Specifications 8.10.26 CF_PJPINCODE Command Command "CF_PJPINCODE_%1"[CR] %1 "0000" - "9999" ---------Set PJ PIN CODE directly Set PJ PIN CODE to release PJ LOCK. PIN CODE cannot be changed by this command. Details -When PJ LOCK is in operation PIN CODE is correct Command is valid (Acceptable) PIN CODE is incorrect Command is invalid(Error Code"102") PIN CODE is out of %1 range Command is invalid (Error Code "? ") -When PJ LOCK is not in operation PIN CODE is within %1 range Command is valid (Acceptable) PIN CODE is out of %1 range Command is invalid (Error Code "? ") Response This command is valid during a dialog "PJ PIN CODE" is displayed after Power On and Count down. Also when PJ LOCK setting is "On1", it is necessary to transmit this command every time lamp turns on. Acceptable "000"[CR] Unacceptable "Error Code"[CR] 8.10.27 CF_FANMODE Command Command "CF_FANMODE_%1"[CR] %1 "L1 Set Fan Mode to L1 "L2 Set Fan Mode to L2 Details Switch Fan Mode When L1 is selected, fan noise after POWER OFF is louder. When L2 is selected, fan noise after POWER OFF becomes quiet. However fan rotates longer than L1. The status set by this command is stored in EEPROM and its setting is effective even after ALL is OFF. This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.28 CF_FANCONTROL Command Command "CF_FANCONTROL_%1"[CR] "OFF Set Fan control to Off %1 "ON1 Set Fan control to On1 "ON2 Set Fan control to On2 Details Set Fan control setting. The status set by this command is stored in EEPROM and its setting is effective even after ALL is OFF. This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 42/72