Ricoh IM 7000 User Guide - Page 281
Please wait. Specified, The Wireless LAN
View all Ricoh IM 7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 281 highlights
When Other Messages Appear Message Cause Solution and reference "Incompatible USB device has been connected. Check the USB device." The machine accidentally detected a USB cable as unusable because dust accumulated in the USB port. • Clean the USB ports on the back side and the back left side of the machine after turning off the power of the machine. page 15 "Turning On and Off the Power" • If the problem persists, consult your service representative. "Internal cooling fan is active." The fan installed in the vent for cooling the interior of the machine became active after a large number of pages has been printed. You may hear a rotating noise while the fan is active, but you can continue using the machine as usual. "Output Tray is full. Remove paper." The output tray is full. Remove the paper from the output tray. When the finisher tray is specified as the output destination, press [Stop] to pause printing and then remove the output paper to prevent paper from falling off the tray. "Problems with the wireless board. Please call service." The Wireless LAN board can be accessed, but an error has been detected. Turn off the power of the machine, check that the Wireless LAN board is correctly installed in the machine, and then turn on the power. page 15 "Turning On and Off the Power" If the message persists even after you have turned the power off and then on, consider repairing the machine. "Updating the destination list... Please wait. Specified destination(s) or sender's name has been cleared." A destination is being registered using Web Image Monitor. Wait until the message disappears and do not turn off the power of the machine. You may not be able to perform operations for a while depending on the number of destinations being registered. 279