Rane Sixty-Eight Sixty-Eight Mixer Manual for Serato DJ - Page 30
Mounting Bracket Accessories
View all Rane Sixty-Eight manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
OWNER'S MANUAL ADD 3.5" (8.9 cm) MINIMUM CLEARANCE FOR CABLES .65" (1.6 cm) PROJECTION Mounting Bracket Accessories When installing a Sixty-Eight mixer in a coffin case, it is important to leave 3.9 inches (10 cm) in front and in back of the mixer to allow room for cables and access to controls. The rubber feet provided on the chassis for table top use should remain in place when installing the mixer in a coffin case. When in operation, the coffin case setup must provide 0.39 inches (1 cm) clearance on each side of the mixer and above the controls on the face of the mixer. Two mounting bracket kits are available for the SixtyEight Mixer. Brackets install easily with three screws on each side. These are powder-coated .075" steel, matching the paint of the mixer. Diagrams and placement are shown on the next page. 14" EARS bring the total width of the mixer to 13.3" (33.78 cm) for coffin mounting. These measure 14" x .75" x 3" (35.8 x 1.9 x 7.7 cm). Shipping weight is 3 pounds (1.36 kg). 19" EARS bring the total width of the mixer to 19" (48.26 cm) for rack mounting. These measure 14" x 3.6" x 3" (35.8 x 9.2 x 7.7 cm). Shipping weight is 5 pounds (2.27 kg). 14.2" (36 cm) If you live in the U.S.A, you may buy these ears in the Rane Factory Store at dj.rane.com. Outside the U.S.A, contact your international representative, contact information is at at rane.com. .7" (1.8 cm) PROJECTION 3.25" (8.3 cm) .6" (1.5 cm) PROJECTION ADD 3.5" (8.9 cm) MINIMUM CLEARANCE FOR PHONES SIXTY-EIGHT 30