Panasonic HX-A1M Basic Owners Manual - Page 9
Using this unit underwater, Caring for this unit after using it underwater
View all Panasonic HX-A1M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
4 Check that the terminal cover (waterproof), glasscover and rubber seals are neither cracked nor deformed. ≥ Be sure to read the supplied leaflet about the rubber seals. 5 Rotate the terminal cover (waterproof) and glasscover until they are attached firmly. ≥ Rotate them in the opposite directions of Step 1. ≥ Tighten them firmly to ensure that they are not loose. ≥ To prevent water seeping into this unit, be careful not to trap foreign objects such as liquids, sand, hair or dust etc. Using this unit underwater ≥ Use this unit underwater at a depth of down to 1.5 m (5.0 feet) with the water temperature between 0 oC and 35 oC (32 oF and 95 oF). ≥ Do not use this unit at a depth of over 1.5 m (5.0 feet). ≥ Do not use it in hot water over 35 oC (95 oF) (in a bath or hot spring). ≥ Do not use this unit underwater not longer than 30 minutes continuously. ≥ Do not attach/remove the terminal cover (waterproof) or glasscover. ≥ Do not apply shock to this unit underwater. (Waterproof performance may not be maintained, and there is a chance of water leak.) ≥ Do not dive into the water holding this unit. Do not use this unit in a location where the water will splash strongly, such as rapid flow or waterfall. (Strong water pressure may be applied, and it may cause malfunction.) ≥ This unit will sink in the water. Take care not to drop this unit. Caring for this unit after using it underwater Do not attach/remove the terminal cover (waterproof) or glasscover until you remove the sand and dust by rinsing this unit. Make sure to clean the camera after using it. ≥ Thoroughly wipe off any water droplets, sand, and saline matter on your hands, body, hair, etc. ≥ It is recommended to clean the camera indoors, avoiding places where water spray or sand may fall. Do not leave this unit uncared for longer than 60 minutes after using it underwater. ≥ Leaving this unit with foreign objects or saline matter on it may cause damage, discoloration, corrosion, unusual odour, or deterioration of the waterproof performance. 1 Rinse this unit without removing the terminal cover (waterproof) and glasscover. ≥ After use at the seaside or underwater, soak the unit in fresh water pooled in a shallow container for about 10 minutes. 2 Drain water by holding this unit and shaking it lightly a few times. ≥ After using this unit at the seaside or underwater, or after washing it, water will remain at the mic site of this unit for a while and it may cause lower sound or sound distortion. ≥ Pay careful attention to prevent this unit from dropping. 3 Wipe off water drops on this unit with a soft dry cloth and dry this unit in a shaded area that is well ventilated. ≥ Dry this unit 1 hour or more. ≥ Dry this unit on a dry cloth. ≥ Do not dry this unit with hot air from dryer or similar. It will deteriorate the waterproof performance or cause failure due to deformation. ≥ Do not use chemicals such as benzine, thinner, alcohol or cleanser, soap or detergents. 4 After checking that there are no water droplets, remove the terminal cover (waterproof) and glasscover, and wipe off any water droplets or sand left inside with a soft, dry cloth. 9 (ENG) SQT0885