NordicTrack C 990 Instruction Manual - Page 32

SYMPTOM: The walking belt slips when walked on a. First, remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller screws clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened. a SYMPTOM: The tablet holder does not stay in place a. Rotate the tablet holder (C) backwards. Then, tighten the indicated screw (D) slightly until the tablet holder stays in place when it is rotated to the desired position. a SYMPTOM: The treadmill will not connect to the wireless network a. Make sure that the wireless settings on the console are correct (see page 27). b. Make sure that the settings for your wireless network are correct. c. If you still have questions, go to support.iFit.com. SYMPTOM: The displays of the console do not function properly a. If the console does not boot up properly, or if the console freezes and does not respond, reset the console to the factory default settings. IMPORTANT: Doing this will erase all the custom settings you have made to the console. Resetting the console requires two people. First, power off the treadmill. Next, locate the small reset opening (E) near the USB port on the console. Using a bent paper clip (F), press and hold the reset button inside the opening, and have a second person power on the treadmill. Continue holding the reset button until the console turns on. When the reset operation is complete, the console will turn off and then turn back on. If it does not, power the treadmill off and then on again. Once the console turns on, check for firmware updates (see HOW TO USE THE MAINTENANCE SECTION on page 26). Note: It may take a few minutes for the console to be ready for use. a C D E F 32