NordicTrack C 990 Instruction Manual - Page 16

20. Firmly tighten the four 3/8" x 2 1/4" Screws (7) and the two 3/8" x 1 1/4" Screws (63). 20 Next, tighten the two 3/8" x 1 3/4" Screws (62); the Wheels (25) must turn freely. Next, set the Left Inner Base Cover (99) onto the lower end of the Left Upright (89). Slide the Left Base Cover (82) downward and press it onto the Left Inner Base Cover. 83 Then, set the Right Inner Base Cover (100) onto the lower end of the Right Upright (90). Slide the Right Base Cover (83) downward and press it onto the Right Inner Base Cover. 89 82 99 63 7 62 25 100 63 90 7 62 25 21. Press the two tabs on the Tablet Holder (98) into the slots (R) in the console assembly (J). 21 Attach the Tablet Holder (98) with four #8 x 5/8" Machine Screws (38). Note: Start the top two Machine Screws first, and then start the bottom two Machine Screws. Be careful not to overtighten the Machine Screws. IMPORTANT: The Tablet Holder (98) is designed for use with most full-size tablets. Do not place any other electronic device or object in the Tablet Holder. 98 Start First R 38 J 22. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 31 and 32). Note: Extra hardware may be included. 16