Metabo SE 17-200 RT Operating Instructions - Page 16

en ENGLISH the battery pack is inserted while the machine is on. Switch the machine off and back on again. 11. Accessories Only use original Metabo battery packs and Metabo accessories. Use only accessories that fulfil the requirements and specifications listed in these operating instructions. Batter chargers: ASC Ultra, ASC 30-36, etc. Battery packs with different capacities. Use battery packs only with voltage suitable for your power tool. Order no.: 6.25346 ... 3.5 Ah (LiHD) Order no.: 6.25342 ... 5.5 Ah (LiHD) Order no.: 6.25345 ... 7.0 Ah (LiHD) etc. Order no.: 6.25591 .... 4 Ah (Li-Ion) Order no.: 6.25592 .... 5.2 Ah (Li-Ion) etc. Fleece/sanding sleeves Grinding wheel Round wire brushes Expansion rollers Polishing rings Auxiliary materials for polishing For a complete range of accessories, see www.metabo.com or the catalogue. 12. Repairs Repairs to power tools must only be carried out by qualified electricians! If the connection lead is damaged, it must be replaced by a special connection lead. Contact your local Metabo representative if you have Metabo power tools requiring repairs. See www.metabo.com for addresses. You can download a list of spare parts from www.metabo.com. 13. Environmental Protection The generated sanding dust may contain harmful substances: dispose of appropriately. Observe national regulations on environmentally compatible disposal and on the recycling of disused tools, packaging and accessories. Only for EU countries: never dispose of power tools in your household waste! In accordance with European Directive 2002/96/EC relating to electrical and electronic waste and implementation of national law, used electrical tools must be collected separately and disposed of in an environmentally friendly manner at recycling centres. Special notes regarding cordless machines: Battery packs may not be disposed of with regular waste. Return faulty or used battery packs to your Metabo dealer! Do not allow battery packs to come into contact with water! Discharge the battery pack in the power tool before disposal. Prevent the contacts from short-circuiting (e.g. by protecting them with adhesive tape). 14. Technical Specifications Explanatory notes on the specifications on page 3. Subject to change in accordance with technical progress. D = Permitted wheel diameter MBmax = maximum wheel width = Spindle thread l = Length of spindle n* = No-load speed (maximum speed) U = Voltage of battery pack PPm12 = Rated input power = Power output = Weight with smallest battery pack/weight without cord Measured values determined in conformity with EN 60745. Direct current (cordless machines) ~ Alternating current (mains powered machines) Machine in protection class II (mains powered machines) * SE 17-200 RT: High-energy, high-frequency interferences can cause speed fluctuations. The fluctuations disappear, however, as soon as the interference fades away. The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards). Emission values These values make it possible to assess the emissions from the power tool and to compare different power tools. The actual load may be higher or lower depending on the operating conditions, the condition of the power tool or the accessories. Please allow for breaks and periods for assessment purposes when the load is lower. Arrange protective measures for the user, such as organisational measures based on the adjusted estimates. Vibration total value (vector sum of three directions) determined in accordance with EN 60745: aKhh,,PP = Vibration emission value (polishing) =Uncertainty (vibration) Typical A-weighted sound levels: LLKpWpAAA, = Sound pressure level = Acoustic power level KWA=Uncertainty Wear ear protectors! 16