LiftMaster CSL24UL Installation Manual - Page 53

ACCESSORIES Miscellaneous Post-mounting plate For post-mounting models CSL24UL, CSW24UL CSW200UL and SL3000UL commercial gate operators. Posts not included. Model MPEL Remote antenna extension kit The remote antenna extension kit allows the antenna to be remotely installed. Model 86LM LiftMaster® internet gateway Internet enabled accessory which connects to the computer and allows you to monitor and control gate operators and lighting accessories enabled by MyQ® technology. Model 828LM LiftMaster Cloud™ connected access protocol high capacity Model CAPXL Plug-in loop detector Low power. Conveniently plugs into existing control board. Model LOOPDETLM Warning sign Model 40-39235 Loop Detector Low power loop detectors mounted and wired separately inside control box. LiftMaster low power accessory. Model LD7LP Vehicle sensing probe The vehicle sensing probe is buried in the ground and can detect a car as it approaches and will then open the gate. Model CP3 Solar panel kit This kit is to replace or add a solar panel to the operator application. 60W maximum for 24 Vdc operators and 30W maximum for 12 Vdc operators. Requires a 33AH battery harness. Models SP10W12V (10 Watt, 12V) and SP20W12V (20 Watt, 12V) Magnetic gate lock Outdoor magnetic lock, transformer, junction box, mounting plate and hardware. Not for use with Solar Applications. Must be powered separately. Model MG1300 Transformer kit Changes input voltage (208/240/480/575 Vac) to an output voltage of 120 Vac. Rated 208/240/480/575 Vac, 4.8/4.2/2.1/1.7 A, 60 Hz, 1 PH Model 3PHCONV Solenoid lock harness kit Model K77-37972 Batteries Gate access system batteries replace or upgrade the gate operator batteries. Two identical 12 Vdc batteries are required for each gate operator. Do not mix 7AH and 33AH batteries within a gate operator. 7AH batteries Standard 7 AMP-Hour Battery, 12 Vdc, to replace original batteries provided with operator. Reuse existing harnesses. Models 29-NP712 (1) and K74-30762 (2) 33AH batteries Upgrade 33 AMP-Hour Battery, 12 Vdc. Ideal for solar applications and extended battery backup. Two required. Model A12330SGLPK Heater The heater keeps the gearbox and batteries at a suitable temperature when the outside temperature is below -4°F (-20°C). The thermostat MUST be set between 45°F and 60°F (7°C and 15.5°C) to ensure proper gate operation. The heater can be powered by 110 to 250 Vac. Model HTR Battery tray Two required for 33AH applications. Model K10-34758-2 Universal solar wire harness kit For 7AH and 33AH applications. Model K94-37236 53