Home » LiftMaster Manuals » Garage Door Openers » LiftMaster CSL24UL » Manual Viewer

LiftMaster CSL24UL Installation Manual - Page 36

Batteries, Drive Train

Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

MAINTENANCE Batteries Batteries will degrade over time depending on temperature and usage. The operator alarm will beep 3 times with a command if the battery is low. Batteries do not perform well in extremely cold temperatures. For best performance, the batteries should be replaced every 3 years. Use only LiftMaster part 29-NP712 for replacement batteries. The batteries contain lead and need to be disposed of properly. The operator comes with two 7AH batteries. Two 33AH batteries (A12330SGLPK), with Solar Harness Kit (K94-37236) may be used in place of the 7AH batteries. Drive Train Over time, the drive chain on the operator will stretch and need to be tightened. To tighten the drive chain adjust either of the two chain eye bolts. NOTE: The chain should have no more than 1 inch of sag for every 10 feet of chain length. 36

Section	Page
CSL24UL VEHICULAR SLIDE GATE OPERATOR	1
TABLE OF CONTENTS	2
SAFETY	2
Safety Symbol and Signal Word Review	2
Usage Class	3
UL325 Entrapment Protection Requirements	3
Safety Installation Information	4
Gate Construction Information	5
INTRODUCTION	6
Carton Inventory	6
Operator Specifications	7
Site Preparation	8
INSTALLATION	9
Types of Installations	9
Step 1 Determine Location for Operator	10
Step 2 Install the Operator	11
Step 3 Attach the Chain	12
Step 4 Install Entrapment Protection	14
Step 5 Earth Ground Rod	16
Step 6 Power Wiring	16
Step 7 Connect Batteries	18
Step 8 Dual gate setup	20
Step 9 Install the cover	22
ADJUSTMENT	23
Limit and Force Adjustment	23
Obstruction Test	24
PROGRAMMING	25
Remote Controls (Not Provided)	25
LiftMaster Internet Gateway (notprovided)	26
Erase All Codes	26
Erase Limits	26
Constant Pressure Override (CPO)	26
Gate Hold Open Feature	26
To Remove and Erase MonitoredEntrapment Protection Devices	26
OPERATION	27
Gate operator setup examples	27
Control Board Overview	28
Manual Disconnect	29
Reset Switch	29
Operator Alarm	29
Remote control	29
ACCESSORY WIRING	30
External control devices	30
Locks	31
Miscellaneous wiring	31
EXPANSION BOARD	32
Expansion board overview	32
Auxiliary relay 1 and 2	33
Wiring accessories to the expansion board	34
MAINTENANCE	35
Maintenance Chart	35
Batteries	36
Drive Train	36
TROUBLESHOOTING	37
Diagnostic Codes	37
Diagnostic Codes Table	38
Control Board LEDs	40
Troubleshooting Chart	41
APPENDIX	44
Step 6 Solar Panel(s)	44
SAMS wiring with relays not energized	48
Dual Gate Settings	48
Limit Setup with a Remote Control	49
WIRING DIAGRAM	50
REPAIR PARTS	51
ACCESSORIES	52
WARRANTY	54

Match case Limit results 1 per page

Batteries

Batteries will degrade over time depending on temperature and usage. The operator alarm will beep 3 times with a command if the battery is low. Batteries

do not perform well in extremely cold temperatures. For best performance, the batteries should be replaced every 3 years. Use only LiftMaster part

29-NP712 for replacement batteries. The batteries contain lead and need to be disposed of properly.

The operator comes with two 7AH batteries. Two 33AH batteries (A12330SGLPK), with Solar Harness Kit (K94-37236) may be used in place of the 7AH

batteries.

Drive Train

Over time, the drive chain on the operator will stretch and need to be tightened. To tighten the drive chain adjust either of the two chain eye bolts.

NOTE:

The chain should have no more than 1 inch of sag for every 10 feet of chain length.

MAINTENANCE