LiftMaster 889LM Instructions - English French Spanish Manufactured Prior to 2
LiftMaster 889LM Manual
View all LiftMaster 889LM manuals
Add to My Manuals
Save this manual to your list of manuals |
LiftMaster 889LM manual content summary:
- LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 1
MyQ® CONTROL PANEL MODEL 889LM APPLICATION The MyQ Control Panel is intended to be installed with Security+® Garage Door Openers manufactured between 1998 and present. The MyQ Control Panel is NOT compatible with Security+ 2.0® Garage Door Openers. DO NOT install this door control on garage door - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 2
the house. *MyQ accessories may be programmed to the LiftMaster® Internet Gateway (Model 828LM) or the MyQ control panel. For instructions on programming to the internet gateway refer to the manual. LIFTMASTER® INTERNET GATEWAY (NOT PROVIDED) The LiftMaster Internet Gateway gives you control of - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 3
switch ON or OFF. TIMER-TO-CLOSE (TTC) NOTE: DO NOT install this door control on garage door opener systems controlling onepiece or swing doors. stop flashing and normal operation will resume. * Your LiftMaster® keypad will continue to work when the LOCK has been activated. To cycle through the - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 4
slowly, the control panel is not compatible with your garage door opener. • If the yellow and red LEDs are blinking quickly, the control panel is charging, and may take up to 5 minutes to become operational. WARRANTY FIVE YEAR LIMITED WARRANTY LiftMaster warrants to the first consumer purchaser of - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 5
ACCESSOIRES COMPATIBLES Accessoires LiftMaster® Modèle 829LM Moniteur de porte de garage et de portail PANNEAU DE COMMANDE MyQ® MODÈLE 889LM Pour éviter le risque de BLESSURES GRAVES ou LA MORT par électrocution : • Veillez à couper le courant AVANT d'installer . Lorsque la batterie est en mode - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 6
MyQ peuvent être programmés pour la passerelle Internet LiftMaster®(modèle 828LM) ou le panneau de commande MyQ. Pour obtenir des instructions sur la programmation de la passerelle Internet, reportez-vous façon de connecter votre ouvre-porte de garage, aller à LiftMaster.com/customer-support. 6 - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 7
consécutives ou si les détecteurs inverseurs de sécurité sont mal installés. La porte de garage remonte et restera ouverte TANT QUE les obstructions le fonctionnement normal reprend. * Votre clavier d'ouverture sans clé LiftMaster® continuera de fonctionner quand la fonction Serrure (LOCK) a été - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 8
de commande n'est pas compatible avec votre ouvre-porte de LE SERVICE CLIENTÈLE : 1-800-528-9131 LiftMaster.com installé et utilisé conformément aux instructions, peut causer un brouillage nuisible aux communications radio. Cependant, rien ne garantit l'absence de brouillage dans une installation - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 9
ahora. El panel de control MyQ NO es compatible con abre-puertas de garaje Security+ 2.0®. NO instale este control de puerta en sistemas de abre-puertas Modelo 828LM LiftMaster® Internet Gateway Modelo 829LM Puerta de garaje y monitoreo de la puerta PANEL DE CONTROL MyQ® MODELO 889LM Para evitar - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 10
a la puerta de entrada del Internet, consulte el manual. INTERNET GATEWAY LIFTMASTER® (NO INCLUIDO) El Internet Gateway LiftMaster le permite controlar la puerta de garaje desde su obtener más información sobre la conexión de su abre-puertas de garaje visite LiftMaster.com/customer-support. 10 - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 11
minuto Botón "ON" TEMPORIZADOR DE CIERRE (TTC) (ACTIVADO) NOTA: NO instale este control de puerta en sistemas de abre-puertas de garaje que controlan puertas de á la operación normal. Minutos * Su llave digital de LiftMaster® continuara trabajando cuando se activar 4 4 ½ BLOQUEO. Minutos - LiftMaster 889LM | Instructions - English French Spanish Manufactured Prior to 2 - Page 12
LED amarillo y rojo están destellando lentamente, el panel de control no es compatible con su abre-puerta de garaje. • S i los LED amarillo y MARQUE NUESTRO NÚMERO GRATUITO PARA RECIBIR SERVICIO: 1-800-528-9131 LiftMaster.com ADVERTENCIA: Este dispositivo cumple con la Parte 15 de la reglamentaci
1
MyQ
®
CONTROL PANEL
MODEL 889LM
To prevent possible SERIOUS INJURY or DEATH from electrocution:
•
Be sure power is NOT connected BEFORE installing door control.
• Connect ONLY to 7-28 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing garage door:
•
Install door control within sight of garage door, out of reach of children at a
minimum height of 5 feet (1.5 m) above floors, landings, steps or any other
adjacent walking surface, and away from ALL moving parts of door.
•
NEVER permit children to operate or play with door control push buttons or
remote control transmitters.
•
Activate door ONLY when it can be seen clearly, is properly adjusted, and
there are no obstructions to door travel.
•
ALWAYS keep garage door in sight until completely closed. NEVER permit
anyone to cross path of closing garage door.
•
DO NOT install this door control on garage door opener systems controlling
one-piece or swing doors.
To provide an adequate visual alert, the garage door opener light bulb(s) MUST
be a minimum of 40 Watt (or equivalent).
The MyQ Control Panel is intended to be installed with Security+
®
Garage Door
Openers manufactured between 1998 and present. The MyQ Control Panel is NOT
compatible with Security+ 2.0
®
Garage Door Openers. DO NOT install this door
control on garage door opener systems controlling one-piece or swing doors.
APPLICATION
The MyQ Control Panel offers a quick and convenient way to add Security+ 2.0 and
MyQ technology to your existing garage door opener. MyQ technology uses a
900MHz signal to provide two-way communication between the garage door
opener and MyQ enabled accessories. When programmed to the LiftMaster
®
Internet Gateway you can monitor and control your garage door from any internet
enabled computer or smartphone. You may program up to 12 Security+ 2.0
remote controls, 2 Security+ 2.0 keyless entries and a combination of 16 MyQ
accessories to the MyQ control panel.
COMPATIBLE ACCESSORIES
Security+ 2.0
®
Accessories:
MyQ Accessories:
Model 891LM
1- Button Remote Control
Model 823LM
Remote Light Switch
Model 893LM
3-Button Remote Control
Model 825LM
Remote Light Control
Model 890MAX
3-Button Mini MAX Remote Control
Model 828LM
LiftMaster
®
Internet Gateway
Model 893MAX
3-Button MAX Remote Control
Model 829LM
Garage Door and Gate Monitor
Model 895MAX
3-Button Premium MAX Remote Control
Model 877LM
Wireless Keyless Entry
Model 877MAX
Wireless MAX Keyless Entry
OVERVIEW
Install the MyQ Control Panel in place of the existing door control, within sight of
garage door, out of reach of small children at a minimum height of 5 feet (1.5 m)
above floors, landings, steps or any other adjacent walking surface, and away from
ALL moving parts of door. Due to power consumption the MyQ Control Panel
cannot be used in conjunction with another wired door control connected to your
garage door opener. If an additional door control is needed, the
wireless door
control model 885LM
can be programmed to the MyQ Control Panel.
To program the 885LM to the MyQ Control Panel, follow the remote control
programming steps. When in battery back-up mode, any feature using unattended
operation such as Timer-to-Close, closure from a garage door and gate monitor or
remote operation utilizing the LiftMaster
®
Internet Gateway will be disabled.
1.
Disconnect all electrical and battery power (if applicable) to the garage door
opener.
2.
Remove the existing door control from the wall.
3.
Note the polarity of the wires connected to the existing door control.
• Label the wire connected to the RED terminal.
• Label the wire connected to the WHITE terminal.
Disconnect the wires from the existing door control.
4.
Connect the wires to the new MyQ Control Panel. Make sure the polarity is
correct.
• Red wire to the R terminal.
• White wire to the W terminal.
INSTALLATION
Existing Door Control
Discard, donate
or recycle
Wire from
RED terminal
Connect
RED wire to
R
terminal
Wire from
WHITE
terminal
Connect
WHITE
wire to
W
terminal
MyQ Control Panel
5.
Mount the MyQ Control Panel to the wall.
6.
Reconnect power. The yellow command LED and the red learn LED will
blink quickly for up to 5 minutes as the control panel recharges. When the
control panel is operational, the yellow command LED will glow steadily.
7.
To test the control panel, press the push bar to activate the garage door
opener.
WARNING:
This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer or
birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.