Kenwood TM-D700A User Manual 1 - Page 79
Microphone Control With Mc-53dm Only
![]() |
View all Kenwood TM-D700A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
MICROPHONE CONTROL (WITH MC-53DM ONLY) You can change numerous transceiver settings by operating the Mic DTMF keys. To activate this function, access Menu 1-8-5 (MIC CONTROL) and select "ON". The following table shows what function is switched ON and OFF or which setting is changed, by pressing the DTMF keys. 1 Visual Scan 9 Squelch Adjustment 2, 3 2 Tone/ CTCSS/ DCS 0 TX Power Change 3 Reverse A Enter 4 1 MHz Step Change B Control Band Select 5 Monitor C Repeater 6 Frequency Readout by Beeps 1 D [F] key 7 Volume Change 2, 3 Down 4 8 Speaker Mute # Up 4 1 The transceiver announces the displayed information if you have installed an optional VS-3 unit and selected "English" in Menu 1-2-4 (VOICE) {page 83}. 2 After entering the selection mode, press [ ] or [#] to change the level or selection. 3 Both Volume Change and Squelch Adjustment cannot be activated at the same time. 4 Both Volume Change and Squelch Adjustment must be OFF to change the tone or frequency step using this key. You can also make the following settings by pressing [D] first (ex. [D], then [2]). 2 Tone (or CTCSS) Frequency/ DCS Code Select 1 3 Offset Direction Select 8 Sub-band Select D Multi-function Mode Cancel 5 DTMF Keypad Lock Down 6 DTMF Keypad Unlock # Up 7 Band A/ B Select 1 After entering the selection mode, press [ ] or [#] to change the level or selection. Before pressing [D], [2], press [2] to activate the Tone, CTCSS, or DCS function. Press [OK] on the front panel of the transceiver to complete the setting. Note: Audible DTMF tones from other transceivers near you may be picked up by your MC-53DM microphone. If so, this could prevent the function from working correctly. 15 73
![](/manual_guide/products/kenwood-tmd700a-user-manual-c2ebc0d/79.png)