Hitachi P7K500 Specifications - Page 225
Hitachi P7K500 - Deskstar - Hard Drive Manual
![]() |
UPC - 683728126674
View all Hitachi P7K500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 225 highlights
10.43.1.4 SMART Save Attribute Values (Subcommand D3h) This subcommand causes the device to immediately save any updated Attribute Values to the device's Attribute Data sector regardless of the state of the Attribute Autosave feature. Upon receipt of the SMART Save Attribute Values subcommand from the host, the device writes any updated Attribute Values to the Attribute Data sector. 10.43.1.5 SMART Execute Off-line Immediate (Subcommand D4h) This subcommand causes the device to immediately initiate the set of activities that collect Attribute data in an off-line mode (off-line routine) or execute a self-test routine in either captive or off-line mode. The Sector Number register shall be set to specify the operation to be executed. Sector Number Operation to be executed 0 Execute SMART off-line data collection routine immediately 1 Execute SMART Short self-test routine immediately in off-line mode 2 Execute SMART Extended self-test routine immediately in off-line mode 4 Execute SMART Selective self-test routine immediately in off-line mode 127 Abort off-line mode self-test routine 129 Execute SMART Short self-test routine immediately in captive mode 130 Execute SMART Extended self-test routine immediately in captive mode 132 Execute SMART Selective self-test routine immediately in captive mode Off-line mode: The device executes command completion before executing the specified routine. During execution of the routine the device will not set BSY nor clear DRDY. If the device is in the process of performing its routine and is interrupted by a new command from the host, the device will abort or suspend its routine and service the host within two seconds after receipt of the new command. After servicing the interrupting command, the device will resume its routine automatically or not start its routine depending on the interrupting command. Captive mode: When executing self-test in captive mode, the device sets BSY to one and executes the specified self-test routine after receipt of the command. At the end of the routine, the device sets the execution result in the Self-test execution status byte (Table 162) and ATA registers as below and executes command completion. Status Error Cyl Low Cyl High Set ERR to one when self-test has failed Set ABRT to one when self-test has failed Set to F4h when self-test has failed Set to 2Ch when self-test has failed HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1) 217
![](/manual_guide/products/hitachi-p7k500-specifications-f1dc015/225.png)