HP XP P9500 HP P9000 Business Continuity Manager Reference Guide (T5253-96058, - Page 368
Table 167 Copy Pair Status Priority, ONACTIONERROR, YKMONOPT
![]() |
View all HP XP P9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 368 highlights
error-action Specifies the error action that is to be executed in the event that the action results in an error. If this value is omitted, the error action specified in the ONACTIONERROR parameter in the YKMONOPT file is executed. Specifiable values are as follows: STOP Places the monitoring status of all copy groups specified in CGID in INACTIVE status. SKIPONLY Skips the cycle where an error occurred, but starts monitoring again from the next cycle. EXIT(return-code) ~ ((0 to 4095)) Stops BCM Monitor with the specified return code. HP recommends that you specify a value other than 0, 4, 8, or 12 because these numbers are already used as BCM Monitor return codes. When there are multiple copy pair statuses in a copy group If there are multiple copy pair statuses in a copy group, one of the copy pair statuses is used as the copy group status to be monitored. If there is a copy pair with one of the high priority levels shown in the table below, that copy pair status is used for the copy group. For example, if there are no copy pairs in the INVALID status, but there is a copy pair in the SUSPER status, then the corresponding copy group is treated as being in the SUSPER status. If there are no copy pairs in the INVALID or SUSPER status, but there is a copy pair in the NODELTA status, then the corresponding copy group is treated as being in the NODELTA status. Table 167 Copy Pair Status Priority Priority 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Copy pair status INVALID CONSLOST SUSPER NODELTA HOLDER SUSPCU SIMPLEX PENDING TRANS HOLDTRNS REVRSY SUSPVS SUSPOP HOLD SWAPPING DUPLEX 368 BCM Monitor Parameter Files
![](/manual_guide/products/hewlettpackard-xp-p9500-hp-p9000-business-continuity-manager-reference-guide-t525396058-2011-10c23c9/368.png)