HP XP P9500 HP P9000 Business Continuity Manager Reference Guide (T5253-96058, - Page 106

If you specify d for multiple fields in AC in the Route Status panel, processing will be performed from bottom to top. Even when d is specified in multiple ACs in the Route Status panel and is specified not to display the Confirm Command Device Delete panel, the Confirm Command Device Delete panel will be displayed after an error and before processing the next volume. NOTE: • If you are using the HP StorageWorks XP1024/XP128 Disk Array, take the target command device offline before executing the YKDELCMD command. • For the following models, you can execute the YKDELCMD command regardless of whether the target command device is online or offline: ◦ HP StorageWorks XP12000/XP10000 Disk Array ◦ HP StorageWorks XP24000/XP20000 Disk Array ◦ HP StorageWorks P9500 Disk Array • When the YKDELCMD command is executed, the copy pair created in the storage system to which the target command device belongs becomes inoperable. Dissolve the copy pair before executing the YKDELCMD command. • When the command device on the primary site is shared between the route of Primary to Local and the route of Primary to Remote in the 3DC Multi-Target configuration route list, the command device on the primary site must be deleted at the end. Command Device Selection Panel If f is selected in the AC column in the Route Status panel, the Command Device Selection List panel for displaying the command devices registered in the storage system is displayed. Figure 94 (page 106) shows the Command Device Selection List panel. Figure 94 Command Device Selection List Panel Table 69 (page 107) describes the items in the Command Device Selection List panel. 106 ISPF Panels