HP AJ732A Cisco MDS 9500 Series Hardware Installation Guide (OL-17467-02, Octo - Page 193
B-8, Alternate Removal Method for Bale Clasp SFP Transceivers, Caution, Step 3
UPC - 883585789481
View all HP AJ732A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
Chapter B Connecting the Cisco MDS 9500 Series Connecting to a Fibre Channel Port Send documentation comments to [email protected]. c. Insert a dust plug into the cable end of the transceiver. Caution If the transceiver does not remove easily in the next step, push the transceiver all the way back in and then ensure that the latch is in the correct position before continuing. Step 3 Remove the transceiver from the port: • If the transceiver has a Mylar tab latch, gently pull the tab straight out (do not twist), and then pull the transceiver out of the port. • If the transceiver has a bale clasp latch, open the clasp by pressing it downwards, and then pull the transceiver out of the port. Note If you have difficulty removing a bale clasp SFP transceiver, you should reseat the SFP by returning the bale clasp in the up position. Then press the SFP inward and upward into the cage. Next, lower the bale clasp and pull the SFP straight out with a slight upward lifting force (see Figure B-8). Be careful not to damage the port cage during this process. Figure B-8 Alternate Removal Method for Bale Clasp SFP Transceivers 115237 Step 4 Step 5 Insert a dust cover into the port end of the transceiver and place the transceiver on an antistatic mat or into a static shielding bag if you plan to return it to the factory. If another transceiver is not being installed, protect the optical cage by inserting a clean cover. OL-17467-02 Cisco MDS 9500 Series Hardware Installation Guide B-13