HP AJ732A Cisco MDS 9500 Series Hardware Installation Guide (OL-17467-02, Octo - Page 178
Migration Procedure for the MDS 9509 Director and MDS 9506 Director
UPC - 883585789481
View all HP AJ732A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
Appendix A Migrating to Generation 3 8-Gbps Fibre Channel Switching Modules Migration Procedure for the MDS 9509 Director and MDS 9506 Director Send documentation comments to [email protected]. Step 9 switch# show hardware fabric-mode Fabric mode supports Gen3 and above linecards. switch# Refer to the Cisco MDS 9000 Family CLI Configuration Guide or Cisco MDS 9000 Family Fabric Manager Configuration Guide for information on how to configure the MDS 9000 48-port or 24-port 8-Gbps Fibre Channel modules. Migration Procedure for the MDS 9509 Director and MDS 9506 Director Note Do not upgrade to NX-OS 4.1(1b) if a Supervisor-1 module is installed. To use any Generation 3 8-Gbps module in an MDS 9509 Director or MDS 9506 Director, follow these steps: Step 1 Step 2 Step 3 Step 4 Log in to the switch. Verify that the switch is running Cisco NX-OS 4.1(1b) by entering the show version command. If the switch has NX-OS 4.x or higher installed, then Supervisor-2 module is already installed on the switch. Skip to step 7 to install any Generation 3 8-Gbps module. Enter the show module command to determine which supervisor module is in active mode and which is in standby module. Supervisor modules are installed in slot 5 and slot 6 on the MDS 9509 Director and MDS 9506 Director. The following example shows the output of the show module command: switch# show module Mod Ports Module-Type Model Status 4 22 4x1GE IPS, 18x1/2/4Gbps FC Modul DS-X9304-18K9 ok 5 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 active * 6 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 ha-standby Mod Sw Hw World-Wide-Name(s) (WWN) 4 4.1(0.182) 0.304 20:c1:00:05:30:00:a7:9e to 20:d2:00:05:30:00:a7:9e 5 4.1(0.182) 4.0 -- 6 4.1(0.182) 0.0 -- Mod MAC-Address(es) Serial-Num 4 00-19-56-be-65-d0 to 00-19-56-be-65-d8 JAB1107027K 5 00-0c-30-0d-2b-b8 to 00-0c-30-0d-2b-bc JAB074004VE 6 00-05-30-00-52-f2 to 00-05-30-00-52-f6 NA If the switch has Supervisor-1 modules installed, remove the modules according to the instructions in the "Removing Supervisor Modules" section on page 2-39. If the switch has Supervisor-2 modules installed, then skip to Step 6. A-12 Cisco MDS 9500 Series Hardware Installation Guide OL-17467-02