Epson ET-2720 Users Guide - Page 111

Before you set up a WSD port, make sure you installed your product software, and connected your product and computer to the same network. 1. Turn on your product. 2. Print a network status sheet so you can identify the network name and model name for your product on the network. 3. Click or Start and select Computer. 4. On the left side of the window, select Network. 5. Locate your product on the Network screen, right-click it, and select Install. 6. When you see the User Account Control screen, click Continue. Note: If you see an Uninstall screen, click Uninstall and repeat these steps as necessary. 7. When you see the message Your device is ready to use in the Windows taskbar, click the message. 8. On the Driver Software Installation screen, make sure your product is listed as Ready to use. Then click Close. 9. Do one of the following: • Windows 7: Click and select Devices and Printers. • Windows Vista: Click Start and select Control Panel > Hardware and Sound > Printers. 10. Make sure that an icon appears for your product's name on the network. When you use WSD, select your product name to scan over the network. Parent topic: Starting a Scan Using the Product Control Panel Starting a Scan Using the Epson Scan 2 Icon You can start the Epson Scan 2 program to select scan settings, scan, and save the scanned image to a file. Note: If you are using your Epson product with the Windows 10 S operating system, you cannot use the software described in this section. You also cannot download and install any Epson product software from the Epson website for use with Windows 10 S; you must obtain software only from the Windows Store. 111