Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 221

Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 8.4.1.0 8.3.2.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Added the multi-auth option on the C-Series and S-Series. Added the single-host and multi-host options on the C-Series, E-Series, and SSeries. Usage Information • Single-host mode authenticates only one host per authenticator port and drops all other traffic on the port. • Multi-host mode authenticates the first host to respond to an Identity Request and then permits all other traffic on the port. • Multi-supplicant mode authenticates every device attempting to connect to the network on the authenticator port. • Use this command in Interface Batch Mode to enable single-host or multi-host authentication in a dual-homing setup. Related Commands show dot1x interface dot1x mac-auth-bypass Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity Request frame, the system attempts to authenticate the host based on its MAC address. C9000 Series Syntax dot1x mac-auth-bypass To disable MAC authentication bypass on a port, use the no dot1x mac-auth-bypass command. Defaults Command Modes Disabled INTERFACE INTERFACE (BATCH MODE) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.2(1.0) Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. 802.1X 221