Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1401

Parameters interface-cost Enter a unsigned integer value expressed as the link-state metric. The range is from 1 to 65535. Defaults Command Modes Command History Default cost based on the bandwidth. INTERFACE This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 9.1.(0.0) 7.8.1.0 7.4.1.0 8.3.19.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4810 and Z9000. Added support for C-Series. Introduced on the E-Series. Introduced on the S4820T. Usage Information In general, the path cost is calculated as: 10^8 / bandwidth Using this formula, the default path cost is calculated as: • 10-Gigabit Ethernet-Default cost is 1 • 40-Gigabit Ethernet - Default cost is 1 ipv6 ospf dead-interval Set the time interval since the last hello-packet was received from a router. After the time interval elapses, the neighboring routers declare the router down. C9000 Series Syntax ipv6 ospf dead-interval seconds To return to the default time interval, use the no ipv6 ospf dead-interval command. Parameters seconds Enter the time interval in seconds. The range is from 1 to 65535 seconds. Defaults Command Modes 40 seconds (Ethernet). INTERFACE Open Shortest Path First (OSPFv2 and OSPFv3) 1401