Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1513

45 Policy-based Routing (PBR) Policy-based routing (PBR) allows you to apply routing policies to specific interfaces. To enable PBR, create a redirect list and apply it to the interface. After the redirect list is applied to the interface, all traffic passing through the interface is subject to the rules defined in the redirect list. PBR is supported by the Dell Networking Operating System (OS). You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or virtual local area network [VLAN]). Trace lists and redirect lists do not function correctly when you configure both in the same configuration. NOTE: Apply PBR to Layer 3 interfaces only. NOTE: For more information , refer to Content Addressable Memory (CAM) chapter. Topics: • ip redirect-group • ip redirect-list • permit • redirect • seq • show cam pbr • show ip redirect-list ip redirect-group Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by entering this command multiple times. C9000 Series Syntax ip redirect-group redirect-list-name To remove a redirect list from an interface, use the no ip redirect-group name command. Parameters redirect-list-name Enter the name of a configured redirect list. Defaults Command Modes Command History none INTERFACE This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Policy-based Routing (PBR) 1513