Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1875

show logging kernellog Display the kernel log for the specified hardware component. C9000 Series Syntax show logging kernellog {cp | rp | linecard slot-id | pe pe-id stack unit unitnumber} From a PE console, use show logging kernellog stack-unit unit number to display the kernel logging information for a specified stack-unit. Parameters cp rp linecard slot-id pe pe-id stack unit unit number Enter the keyword cp to display the kernel log for the Control Processor on the switch. Enter the keyword cp to display the kernel log for the Route Processor on the switch. Enter the linecard slot-id parameters to specify the line-card ports for which you want to display the kernel log. The range of line-card slot IDs is from 0 to 2. Enter the keyword pe and the port extender the ID to display the kernel log for the specified port extender. The PE ID range is from 0 to 255. Enter keyword stack-unit and the stack-unit number to display the kernel log for the specified stack unit. Stack-unit number range is from 0 to 7. defaults Command Modes none • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.11(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 Description Introduced on N20xx and N30xx series. Introduced on the C9010 and C1048P. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Usage Information This command displays internal software driver information, which may be useful during troubleshooting switch initialization errors, such as a downed port pipe. Simple Network Management Protocol (SNMP) and Syslog 1875