DeLonghi ESAM5600SL Owner Manual - Page 16

of the appliance (accessible after removing the drip tray) is not dirty. If necessary, remove coffee deposits with the brush provided and a sponge. 2. Remove the residues with a vacuum cleaner (fig. 36). Cleaning the water tank 1. Clean the water tank (A13) regularly (about once a month) with a damp cloth and a little mild washing up liquid. 2. After cleaning the water tank rinse it thoroughly to remo- ve all washing up liquid residues. Cleaning the coffee spouts 1. Clean the coffee spouts with a sponge or cloth (fig. 37). 2. Check the holes in the coffee spout are not blocked. If ne- cessary, remove coffee deposits with a toothpick (fig. 38). Cleaning the pre-ground coffee funnel Check regularly (about once a month ) that the pre-ground coffee funnel is not blocked. If necessary, remove coffee deposits with the brush provided (A23). Cleaning the infuser The infuser (A8) must be cleaned at least once a month. Important! The infuser may not be extracted when the machine is on. 1. Make sure the machine is correctly turned off (see section: "Turning off"). 2. Open the service door (fig. 33). 3. Remove the drip tray and grounds container (fig. 34). 4. Press the two red release buttons inwards and at the same time pull the infuser outwards (fig. 39). Important! RINSE WITH WATER ONLY NO DISH SOAP - NO DISH WASHER Do not use dish soap to clean the infuser as it could cause damage. 5. Soak the infuser in water for about 5 minutes, then rinse under the tap. 6. After cleaning, replace the infuser by sliding it onto the in- ternal support and pin at the bottom, then push the PUSH symbol fully in until it clicks into place. Please Note! shown in the figure. If you encounter difficulty inserting the infuser, before inserting it you must adapt it to the right dimension by pressing it forcefully from the bottom and top as 7. Once inserted, make sure the two red buttons have snapped out. 8. Replace the drip tray and grounds container. 9. Close the service door. Cleaning the milk container Clean the milk container each time you prepare milk as described below: 1. Turn the lid of the milk container clockwise then remove it. 2. Remove the milk spout and intake tube. 3. Remove the froth regulator by pulling it outwards. 4. Wash all the components thoroughly with hot water and mild dish soap. All components can be washed in a dishwasher, placing them in the top basket of the dishwasher. Make sure there are no milk residues left inside the holes and the groove on the fine end of the froth regulator. 5. Use the brush supplied (certain models only) or another brush (not metal) to remove residues from the milk hole. 6. Check that the intake tube and spout are not clogged with milk residues. 7. Replace the froth regulator, milk spout and intake tube. 8. Replace the lid on the milk container, turning it anticlockwise to hook it in place. Cleaning the graphic touch screen 1. If the machine is on, turn off by pressing the button (fig. 5) to avoid starting it accidentally during cleaning. 2. Clean the graphic touch screen with a damp cloth. Do not use solvents, aggressive detergents and/or sharp objects as they could damage the surface of the screen. 18