DeLonghi ESAM5600SL Owner Manual - Page 14

Please Note! If during delivery you want to stop preparing milk, press the CAPPUCCINO icon or interrupt preparation of the coffee by pressing the icon. Making macchiato 1. After attaching the milk container (see previous section), position the froth regulator on LATTE MACCHIATO (fig. 27) printed on the milk container lid. 2. Press the LATTE MACCHIATO icon (fig. 28). A glass is displayed and gradually fills as preparation progresses. After a few seconds, frothed milk flows out of the milk spout into the glass below. Milk delivery stops automatically and coffee delivery begins. 3. At the end of delivery, the machine is automatically ready for use again. Please Note! If during delivery you want to stop preparing milk, press the LATTE MACCHIATO icon or interrupt preparation of the coffee by pressing the icon. Making milk 1. After attaching the milk container (See section: "Filling and attaching the milk container"), position the froth regulator according to the quantity of froth you require (pos. 3 caffelatte = little froth; pos. 1 cappuccino = abundant froth). 2. Press the MILK icon (fig. 29). A glass is displayed and gradually fills as preparation progresses. After a few seconds, frothed milk is delivered from the milk spout into the cup below. 3. After delivery, the machine is automatically ready for use again. Please Note! If during delivery you want to stop preparing milk, press the MILK icon once. (fig. 21). 3. Press the CLEAN button (fig. 30) and keep pressing until the progress bar which appears on the display together with the message "Cleaning..." is complete. 4. Remove the milk container and always clean the nozzle with a sponge (fig. 31). Please Note! • When"Press CLEAN button"flashes on the display, you can still prepare any type of coffee or milk. If you have to make a number of drinks with milk, wait until you have delivered the last cup before cleaning the container. • The milk left in the container can be kept in the refrigerator. • In some cases, to clean you must wait for the appliance to heat up, holding the CLEAN button down. Programming the quantities of coffee and milk in the cup The appliance is set by default to automatically deliver standard quantities. To change these quantities, proceed as follows: 1. Place a cup/glass under the coffee spouts and milk spout (fig. 21). 2. Press the icon corresponding to the function you want to program until "Program Quantity Milk For..." is displayed together with the or icon according to the function selected. 3. Release the icon. The appliance starts delivering milk. 4. When the required quantity of milk has been delivered into the cup, press the icon again. 5. After a few seconds, the appliance starts delivering coffee into the cup and the message "Coffee for... Program quantity"is displayed (with the exception of the MILK function) and the icon flashes. 6. As soon as the coffee in the cup reaches the required level, press the icon. Coffee delivery stops. The machine is now reprogrammed with the new quantities. Cleaning the milk container after use HEATING WATER Important! Danger of burns When cleaning the internal tubes of the milk container, a little hot water leaks out of the frothed milk tube (B5). Avoid contact with splashes of water. When "Press CLEAN button" flashes on the display (each time you use a milk function): 1. Leave the milk container in the machine (you do not need to empty it); 2. Place a cup or other recipient under the frothed milk spout Preparation Important! Danger of burns. Never leave the machine unsupervised while delivering hot water. The hot water spout becomes hot while water is delivering and must be handled by the handle only. 1. Make sure the hot water spout is attached correctly (fig. 4). 2. Place a container under the spout (as close as possible to 16