DIRECTV Sat-Go Owners Manual - Page 32

Setting Up Your DIRECTV® Sat-Go TV INPUT POWER TV ON OFF ACTIVE LIST E TIP: You may decide to set up, change or adjust some of the settings later. When you're ready, press MENU on your remote control, press SELECT on Settings and then select Setup. Guided Setup for DIRECTV® Service Now that your DIRECTV Sat-Go equipment is all hooked up and plugged in, you're ready to finish all the details to begin receiving your DIRECTV service. 1) Make sure the MODE switch on the remote control is set to DIRECTV. 2) Press TV POWER ON. The TV will turn on. 3) The first screen will allow you to select a language. Using the arrow keys on the remote control, move to the language you prefer and press SELECT. 4) You will see a Welcome screen. Now, let us lead the way... Simply follow the onscreen directions to complete your setup functions. If you've set up your antenna, you'll be guided though various functions for optimizing your signal and setup - including positioning your antenna and a system test. After these setup procedures are complete, you'll see the Satellite Data Acquisition screen, as the receiver gathers information from the satellite for the onscreen program guide. Next, you'll be given the opportunity to set up your phone connection, as well as program your remote to control other equipment, such as your DVD player. Just follow the screen instructions and you'll be ready to watch in no time! IMPORTANT: In order to protect your TV screen from burn-in (a side-effect caused when a stationary image is displayed for too long), the TV interface automatically goes into screen saver mode, and displays a black screen with a moving logo when no key is pressed for 5 minutes or more while a stationary image is displayed on the TV. To dismiss the screen saver and return to what you were doing, press any key on the remote. Burn-in may cause permanent damage to your TV. 31