DIRECTV Sat-Go Owners Manual - Page 3

Notices 16) Avoid operating the TV in extreme heat, humidity or areas affected by dust. The operating temperature range is 0~50°C (32~122°F). The operating humidity range is 20~90%. 17) Do not use sharp tools such as a pin or a pencil near the TV, as they may scratch the LCD. 18) Do not use a solvent, such as benzene, to clean the TV, as it will damage the LCD surface. 19) The acrylic exterior surface of the TV can become rough or even sharp as it is exposed to wear. Exercise caution when handling the unit to avoid scratches or minor cuts. • CAUTION: Avoid moisture to reduce the risk of fire or electric shock. The DIRECTV® Sat- Go system should not be used near water (for example, kitchen sink, bathtub, pool, damp basement). Also, never spill liquid on the receiver, and do not place vases or other vessels containing liquid on top of it. • Ensure proper ventilation - the vent slots on the DIRECTV Sat-Go system must be left uncovered to allow proper airflow to the unit. Blocking the airflow to the unit could impair performance or damage your receiver and other components. • Do not stack electronic components or other objects on top of the DIRECTV Sat-Go system. Also, do not stack the receiver on top of a "hot component" such as an audio power amplifier. • Protect your components from power surges by connecting all the components before plugging any power cords into the wall outlet. Use of a surge protector is also recommended. • Don't overload power outlets or extension cords, which can result in the risk of fire or shock. It's also important to use only the type of power source indicated on the marking label or in this manual. • Avoid audio hum or interference by inserting all cable plugs firmly into their jacks. Also, place Audio/Video (A/V) cables to the sides of the TV back panel rather than down the middle once connected. Try not to coil any twin-lead cables and keep them away from A/V cables as much as possible. • Never insert objects of any kind into any openings in the DIRECTV Sat-Go system (other than the DIRECTV access card as detailed in this manual). • Place it on a flat, hard surface - do not operate the DIRECTV Sat-Go system on a carpet or other padded surface. • Always unplug your DIRECTV Sat-Go system before moving it. • Always unplug the DIRECTV Sat-Go system, TV and other equipment before you connect or disconnect any cables. • CAUTION: Electric Shock - never attempt to disassemble the DIRECTV Sat-Go system yourself; always take it to a qualified service person when repair is required. Opening or removing covers may expose dangerous voltage or other risks, and incorrect reassembly can cause shock when receiver is subsequently used. Attempted self-repair may also void your warranty. Changes or modifications not expressly approved by the party responsible for compliance (by the warranty or by the manufacturer) could void the user's authority to operate the equipment. • Do not drop your DIRECTV Sat-Go system, or expose to sudden or jarring movements, and always move it with care. Protect the LCD screen from impact. • Have your DIRECTV Sat-Go system professionally serviced (do not attempt to service it yourself). • Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. • The DIRECTV Sat-Go system should be stored between -20°C and 60°C (-4°F to 140°F). For your information: The identification sticker can be located underneath your DIRECTV Sat-Go system. The telecommunication network voltage used is the category number 3. 2