Brother International TJ-4520TN Users Guide - Page 35

Turn the Print Head Release Lever, Label, Guide Release Lever and Peel-Off Kit

Get Brother International TJ-4520TN PDF manuals and user guides View all Brother International TJ-4520TN manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

7. Close the Print Head on both sides and make sure it locks into place. 8. Set the media sensor type and calibrate the selected sensor. 9. Perform the calibration using the BPM. For more information about sensor calibration, see section 8.2 Auto-Calibrating the Media Sensor using the BPM. Note 1. Calibrate the Gap/Black Mark Sensor before loading media in Peeler Mode to avoid paper jams. 2. Make sure you thread the label over the Media Guide Bar and under the Damper as shown. 10. Turn the Print Head Release Lever, Label Guide Release Lever and Peel-Off Kit, and pull approximately 650 mm of the label roll through the Media Output Slot. 11. Remove some labels leaving only the liner. Label Liner 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
31
7.
Close the Print Head on both sides and
make sure it locks into place.
8.
Set the media sensor type and calibrate
the selected sensor.
9.
Perform the calibration using the BPM.
For more information about sensor
calibration, see section
8.2 Auto-Calibrating the Media Sensor
using the BPM
.
Note
1.
Calibrate the Gap/Black Mark
Sensor before loading media in
Peeler Mode to avoid paper jams.
2.
Make sure you thread the label over
the Media Guide Bar and under the
Damper as shown.
10. Turn the Print Head Release Lever, Label
Guide Release Lever and Peel-Off Kit,
and pull approximately 650 mm of the
label roll through the Media Output Slot.
11. Remove some labels leaving only the
liner.
Label
Liner