BenQ MW612 User Manual - Page 22
Switching input signal, Changing the password, Disabling the password function
View all BenQ MW612 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
1. Press and hold AUTO for 3 seconds. The projector will display a coded number on the screen. 2. Write down the number and turn off your projector. Recall Password Please write down the recall code, and contact BenQ Customer Center. 3. Seek help from the local BenQ service center to decode the number. You may be required to provide proof of purchase documentation to verify that you are an authorized user of the projector. Changing the password Recall Code: Return 1. Go to Advanced Menu - Settings > Security Settings > Change Password. 2. Press OK. The message "Input Current Password" appears. 3. Enter the old password. • If the password is correct, another message "Input New Password" appears. • If the password is incorrect, the password error message will appear, and the message "Input Current Password" appears for your retry. You can press BACK to cancel the change or try another password. 4. Enter a new password. 5. Confirm the new password by re-entering the new password. Disabling the password function To disable password protection, go to Advanced Menu - Settings > Security Settings > Power On Lock and press / to select Off. The message "Input Current Password" appears. Enter the current password. • If the password is correct, the OSD menu returns to the Security Settings page. You will not have to enter the password next time turning on the projector. • If the password is incorrect, the password error message will appear, and the message "Input Current Password" appears for your retry. You can press BACK to cancel the change or try another password. Though the password function is disabled, you need to keep the old password in hand should you ever need to re-activate the password function by entering the old password. Switching input signal The projector can be connected to multiple devices at the same time. However, it can only display one full screen at a time. When starting up, the projector automatically searches for the available signals. Be sure the Advanced Menu - Settings > Auto Source Search menu is On if you want the projector to automatically search for the signals. To select the source: 1. Press SOURCE. A source selection bar appears. 2. Press / until your desired signal is selected and press OK. Once detected, the selected source information will appear at the corner of the screen for seconds. If there is multiple equipment connected to the projector, repeat steps 1-2 to search for another signal. 22 Operation