Adaptec 1430SA User Guide - Page 64
UPDATE, VERIFY, Command Syntax, Command Switches, Examples - aar
UPC - 760884154328
View all Adaptec 1430SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Appendix C: Using the AFU for DOS ● 64 UPDATE The UPDATE command updates a HostRAID controller's flash components from the flash image data in a UFI file. You can use the UPDATE command to update a single HostRAID controller's flash components or to update multiple HostRAID controllers on your computer. You must restart the computer following an UPDATE command. Command Syntax The command syntax for the UPDATE command is as follows: AFU UPDATE [/C] [/D ] Command Switches For details on the /C and /D switches, see SAVE on page 63. Examples The following example shows a typical system response after an update has been performed: A:\> AFU UPDATE /C 0 Adaptec Flash Utility V1.0-0 B1406 (c)Adaptec Inc. 1999-2005. All Rights Reserved. Updating Controller 0 (Adaptec AAR-1430) Reading flash image file (Build 1406) AFU is about to update firmware on controller(s) Adaptec AAR-1430 ***PLEASE DO NOT REBOOT THE SYSTEM DURING THE UPDATE*** This might take a few minutes. Writing Adaptec AAR-1430 (4MB) Flash Image to controller 0...OK. Verifying...OK Please restart the computer to allow firmware changes to take effect. VERIFY The VERIFY command compares the contents of each of the flash components on a HostRAID controller to the corresponding image in a UFI file and indicates whether they match. Use this command to determine whether a HostRAID controller's flash components are up-to-date when compared to a specific UFI file. Command Syntax The command syntax for the VERIFY command is as follows: AFU VERIFY [/C] [/D ] Command Switches For details on the /C and /D switches, see SAVE on page 63.