2009 Yamaha Motorsports RS Venture Owners Manual - Page 51

2009 Yamaha Motorsports RS Venture Manual

Get 2009 Yamaha Motorsports RS Venture PDF manuals and user guides View all 2009 Yamaha Motorsports RS Venture manuals

Page 51 highlights

Periodic maintenance and adjustment 5. Remove the oil filler cap, wipe the dipstick clean, insert it back into the oil filler hole (without screwing it in), and then remove it again to check the oil level. 7. Insert the dipstick into the oil filler hole, and then tighten the oil filler cap. 8. Connect the oil level gauge coupler. 9. Close the shroud. To change the engine oil (with or without oil filter cartridge replacement) 1. Place the snowmobile on a level surface and apply the parking brake. 2. Start the engine, warm it up for several minutes, and then turn it off. 3. Open the shroud. 4. Remove the right side cover and the bottom panel. 1. Oil filler cap 2. Dipstick TIP The engine oil should be between the "H" and "L" level marks on the dipstick. 1. Right side cover 1. "H" level mark 2. "L" level mark 1 1. Bottom panel 6. If the engine oil is below the "L" level mark, add sufficient oil of the recommended type to raise it to the "H" level mark. (See page 72 for the recommended oil.) NOTICE: When adding the engine oil, be careful not to fill above the "H" level mark on the dipstick. Use only the recommended oil. (See page 72.) Make sure that no foreign material enters the engine oil tank. [ECS00462] 5. 6. Place an oil pan under the oil tank to collect the used oil. Disconnect the oil level gauge coupler. 45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
Periodic maintenance and adjustment
45
5.
Remove the oil filler cap, wipe the dipstick
clean, insert it back into the oil filler hole
(without screwing it in), and then remove
it again to check the oil level.
TIP
The engine oil should be between the “H” and
“L” level marks on the dipstick.
6.
If the engine oil is below the “L” level
mark, add sufficient oil of the recom-
mended type to raise it to the “H” level
mark. (See page 72 for the recommend-
ed oil.)
NOTICE:
When adding the en-
gine oil, be careful not to fill above the
“H” level mark on the dipstick. Use
only the recommended oil. (See page
72.) Make sure that no foreign material
enters the engine oil tank.
[ECS00462]
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Connect the oil level gauge coupler.
9.
Close the shroud.
To change the engine oil (with or without oil fil-
ter cartridge replacement)
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Open the shroud.
4.
Remove the right side cover and the bot-
tom panel.
5.
Place an oil pan under the oil tank to col-
lect the used oil.
6.
Disconnect the oil level gauge coupler.
1.
Oil filler cap
2. Dipstick
1.
“H” level mark
2.
“L” level mark
1.
Right side cover
1.
Bottom panel
1