2009 Yamaha Motorsports Phazer M-TX Owners Manual - Page 65

2009 Yamaha Motorsports Phazer M-TX Manual

Get 2009 Yamaha Motorsports Phazer M-TX PDF manuals and user guides View all 2009 Yamaha Motorsports Phazer M-TX manuals

Page 65 highlights

Periodic maintenance and adjustment 9. Remove the engine oil drain bolt to drain the oil from the crankcase. 1. Engine oil drain bolt (crankcase) TIP Dispose of used oil according to local regulations. 10. Install the engine oil drain bolts, and then tighten them to the specified torques. Tightening torques: Engine oil drain bolt (crankcase): 30 Nm (3.0 m·kgf, 22 ft·lbf) Engine oil drain bolt (oil tank): 16 Nm (1.6 m·kgf, 11 ft·lbf) 11. Add 1.5 L (1.59 US qt, 1.32 Imp.qt) of the recommended engine oil to the oil tank, and then install and tighten the oil filler cap. 12. Start the engine, warm it up for several minutes, and then turn it off. 13. Add sufficient oil of the recommended type to raise it to the "H" level mark on the dipstick. (See above for checking procedures.) NOTICE: When adding the engine oil, be careful not to fill above the "H" level mark on the dipstick. Use only the recommended oil. (See page 81.) Make sure that no foreign material enters the engine oil tank. [ECS00462] Recommended engine oil: See page 81. Oil quantity: With oil filter cartridge replacement: 2.6 L (2.78 US qt, 2.31 Imp.qt) Without oil filter cartridge replacement: 2.4 L (2.59 US qt, 2.16 Imp.qt) Total amount: 3.0 L (3.17 US qt, 2.64 Imp.qt) 14. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and make sure that the engine oil drain bolt, oil tank drain bolt, and the oil filler cap are installed correctly. 15. Turn the engine off, and then connect the oil level gauge coupler. 16. Install the bottom panel and the right lower cover. 17. Install the right side cover (PZ50 / PZ50RT / PZ50GT / PZ50MT), or install the right side cover and the right upper cover, and then close the shroud (PZ50VT). NOTICE: If oil is leaking or the oil level warning indicator comes on when the engine is running, immediately turn the engine off and have a Yamaha dealer check the snowmobile. Continuing to operate the engine under such conditions could cause severe engine damage. [ECS00471] 59

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
Periodic maintenance and adjustment
59
9.
Remove the engine oil drain bolt to drain
the oil from the crankcase.
TIP
Dispose of used oil according to local regula-
tions.
10.
Install the engine oil drain bolts, and then
tighten them to the specified torques.
11.
Add 1.5 L (1.59 US qt, 1.32 Imp.qt) of the
recommended engine oil to the oil tank,
and then install and tighten the oil filler
cap.
12. Start the engine, warm it up for several
minutes, and then turn it off.
13. Add sufficient oil of the recommended
type to raise it to the “H” level mark on the
dipstick. (See above for checking proce-
dures.)
NOTICE:
When adding the en-
gine oil, be careful not to fill above the
“H” level mark on the dipstick. Use
only the recommended oil. (See page
81.) Make sure that no foreign material
enters the engine oil tank.
[ECS00462]
14. Start the engine, and then let it idle for
several minutes while checking it for oil
leakage. If oil is leaking, immediately turn
the engine off and make sure that the en-
gine oil drain bolt, oil tank drain bolt, and
the oil filler cap are installed correctly.
15.
Turn the engine off, and then connect the
oil level gauge coupler.
16.
Install the bottom panel and the right low-
er cover.
17. Install the right side cover (PZ50 /
PZ50RT / PZ50GT / PZ50MT), or install
the right side cover and the right upper
cover, and then close the shroud
(PZ50VT).
NOTICE:
If oil is leaking or
the oil level warning indicator comes
on when the engine is running, imme-
diately turn the engine off and have a
Yamaha dealer check the snowmobile.
Continuing to operate the engine un-
der such conditions could cause se-
vere engine damage.
[ECS00471]
1.
Engine oil drain bolt (crankcase)
Tightening torques:
Engine oil drain bolt (crankcase):
30 Nm (3.0 m·kgf, 22 ft·lbf)
Engine oil drain bolt (oil tank):
16 Nm (1.6 m·kgf, 11 ft·lbf)
Recommended engine oil:
See page 81.
Oil quantity:
With oil filter cartridge replacement:
2.6 L (2.78 US qt, 2.31 Imp.qt)
Without oil filter cartridge replacement:
2.4 L (2.59 US qt, 2.16 Imp.qt)
Total amount:
3.0 L (3.17 US qt, 2.64 Imp.qt)