2008 Yamaha Motorsports RS Vector L-TX Owners Manual - Page 68
2008 Yamaha Motorsports RS Vector L-TX Manual
Page 68 highlights
Periodic maintenance 5. Adjust the drive track deflection to specification. Drive track deflection Left adjusting nut Right adjusting nut ECS00591 ECS00350 CAUTION: Ride on fresh snow frequently. Operating on ice or hard-packed snow will rapidly wear the slide runners. ESU12190 More than specified Turn in Turn in Less than specified Turn out Turn out Lubrication Lubricate the following points with the specified grease. EWS00510 CAUTION: The right and left adjusting nuts should be turned an equal amount. 6. Recheck alignment and deflection. If necessary, repeat steps 3 to 5 until the proper adjustment is achieved. Tighten the rear axle nut. Rear axle nut tightening torque: 75 Nm (7.5 m·kgf, 54 ft·lb) WARNING G 7. G Apply a dab of grease onto the cable end only. Do not grease the throttle cable because it could become frozen, which could cause loss of control. Be sure to have a Yamaha dealer lubricate the front and rear suspensions. Lubricant: Low-temperature grease Slide runners Check the slide runners for wear and damage. If the slide runners reach the wear limit, they should be replaced. 1. Throttle cable end 1. Slide runner 2. Wear limit height Slide runner wear limit height: 10.5 mm (0.41 in) 62