2008 Yamaha Motorsports RS Vector L-TX Owners Manual - Page 61
2008 Yamaha Motorsports RS Vector L-TX Manual
Page 61 highlights
Periodic maintenance 9. Rotate the secondary sliding sheave clockwise and push it so that it separates from the secondary fixed sheave. 2. Remove the shroud and the right side cover. (See page 40 for removal procedures.) Remove the dipstick, wipe it off with a clean rag, and then insert it back into the filler hole. 3. 1. Secondary sliding sheave 2. Secondary fixed sheave 10. Install the V-belt between the secondary sliding and fixed sheaves. 1. Dipstick 4. Remove the dipstick and check that the oil is between the maximum and minimum level marks. If the oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the maximum level mark. 1. V-belt 11. Install the drive guard, and then install the left side cover and the shroud. ESU12100 Drive chain housing EWS00430 WARNING The engine, oil tank, brake disc, and coolant hoses will be very hot after the engine has been run. Avoid contact while they are still hot with any part of your body or clothing during inspection or repair. To check the drive chain housing oil level 1. Place the snowmobile on a level surface. 1. Maximum level mark 2. Minimum level mark 55