2008 Yamaha Motorsports Morphous Owners Manual - Page 58
2008 Yamaha Motorsports Morphous Manual
Page 58 highlights
PERIODIC MAINTENANCE AND MINOR REPAIR 5 1 1 1 cap with the spark plug wrench. 8. Install the engine oil filler cap cover by placing it in its original position. 9. Place the floorboard mat in the original position. To change the engine oil (with or without oil filter element replacement) 1. Start the engine, warm it up for several minutes, and then turn it off. 2. Place an oil pan under the engine to collect the used oil. 3. Remove the engine oil filler cap and the engine oil drain bolt to drain the oil from the crankcase. 1 2 2 2 3 4 1. Engine oil filler cap 2. Dipstick 3. Maximum level mark 4. Minimum level mark 5. Spark plug wrench 3 4 5 6 7 8 9 1. Right floorboard mat 2. Engine oil filler cap cover 4. Remove the oil filler cap as shown, with the spark plug wrench included in the owner's tool kit. 5. Wipe the dipstick clean, insert it back into the oil filler hole (without screwing it in), and then remove it again to check the oil level. NOTE: The engine oil should be between the minimum and maximum level marks. 6. If the engine oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. 7. Insert the dipstick into the oil filler hole, and then tighten the oil filler 6-16 1 1. Engine oil drain bolt