2015 Polaris Slingshot SL Owners Manual - Page 60
2015 Polaris Slingshot SL Manual
Page 60 highlights
MAINTENANCE Drive Belt Condition Adjust drive belt tension after the first 2,500 miles (4,000 km) of operation. Replace the drive belt and both sprockets as a set if the drive belt has over 30,000 miles (48,000 km) of service at the time of damage or failure. Replace the drive belt if any inspection reveals cracks, broken teeth or frayed edges. See the SLINGSHOT Service Manual or an authorized dealer. DO NOT attempt to check belt tension if the belt has been exposed to rain or washing within a 24 hour period or if the belt is hot from being in use. Allow the belt to cool down to ambient temperature before measuring belt tension. Drive Belt Wear Analysis Internal tooth cracks (hairline): OK to run, but monitor condition External tooth cracks: Replace belt Missing teeth: Replace belt Chipping (not serious): OK to run, but monitor condition Fuzzy edge cord: OK to run, but monitor condition Hook wear: Replace belt Stone damage: Replace belt if damage is on edge Bevel wear (outboard edge only): OK to run, but monitor condition Drive Belt Cleaning Cleaning the drive belt will maximize belt and sprocket life and minimize drive line noise. Clean the belt at every tire change. Clean the belt more often if operating in dirty, dusty or high debris environments. 1. Mix a few drops of mild dish soap with a cup of warm water. 2. Use a soft nylon brush to clean the belt and sprocket teeth with the soapy water. Clean well in corner areas where road debris and belt dust can collect. 3. Rinse the belt with clear water, then dry thoroughly. NOTE: Do not inspect or adjust drive belt tension when the belt is wet. Improper adjustment will result. 58