2014 Polaris 800 Pro RMK Owners Manual - Page 69

OPERATION Break-In Period Drive Belt/QUICKDRIVE Belt Break-In The length of the break-in period varies depending on the type of drive system. The break-in period for a new drive belt is 30 miles (48 km). The break-in period for a new QUICKDRIVE belt is 100 miles (160 km). • Vary the throttle position and limit full throttle use. • Always take time to warm up the belt and driveline prior to operating the snowmobile. Free the track and skis from the ground before engaging throttle. Break-In Requirements Specific to the QUICKDRIVE Belt • During the 100 miles (160 km) of belt break-in, the rider will hear a sound made by the drive system. After the break-in period, the sound will become similar to that of a traditional chaincase. • Improper track tension can result in track ratcheting, which will affect QUICKDRIVE belt durability. Always maintain proper track tension. See page 106. • During the break-in period, this belt sheds a fiber-type material in and around the drive system. Use a dry shop towel to clean the residue. • Stop occasionally and allow the snowmobile to cool after high throttle/high track load events. This will help the QUICKDRIVE belt achieve maximum performance and it will also break in the engine, drive belt and sprockets properly. • On-trail break-in should be performed at speeds no more than 50 MPH (80 km/h). • Always be cautious when jumping and landing a snowmobile. Avoid "power-on" landings. Damage caused to any component due to improper use or abuse is not covered by warranty. 67