2010 Polaris Vegas Owners Manual - Page 88

Maintenance Rear Wheel Alignment 4. To adjust rear wheel alignment, loosen the rear axle nut about 1 1/2 turns. Tip: Turn the axle adjusters about 1/16 of a turn at a time and monitor wheel alignment as you proceed. Lock Nut Axle Adjuster Screw 5. On screw style adjusters: Use a 17-mm wrench to loosen the lock nut, then use an 8-mm hexagonal wrench to turn the axle adjuster screws. On nut style adjusters: Use a deep 14-mm socket to turn the adjuster nut. 6. On both adjuster styles: Turn the screw or nut IN (clockwise) to draw the axle back, or OUT (counterclockwise) to allow the axle to move forward. Tip: If adjuster screws or nuts are turned OUT (counterclockwise) push the wheel and axle forward to be sure the ends of the adjuster screws or the nuts are seated against the end of the swingarm before inspecting alignment or belt tension. Screw-Style Adjuster Axle Adjuster Nut 7. Recheck rear wheel alignment after each adjustment. Readjust if necessary until alignment is correct and drive belt tension is correct. See page 78. (continued on next page) Nut-Style Adjuster 86