2006 Polaris Ranger XP 700 EFI 4x4 Owners Manual - Page 100
2006 Polaris Ranger XP 700 EFI 4x4 Manual
Page 100 highlights
Cleaning and Storage Storage Tips MAINTENANCE AND LUBRICATION Fog the Engine 1. Treat the fuel system with Polaris Carbon Clean, following the instructions on the can. Run the engine for several minutes so the Carbon Clean reaches the injectors. Turn the engine off. 2. Remove the spark plugs and add 2-3 tablespoons of Premium 4 Synthetic 0W40 engine oil. To access the plug holes, use a section of clear 1/4" hose and a small plastic squeeze bottle filled with the pre-measured amount of oil. NOTE: Do this carefully! If you miss the plug holes, oil will drain from the spark plug cavities into the hole at the front of the cylinder head, and appear to be an oil leak. 3. Reinstall the spark plugs. Torque to specification. See page 70. 4. Apply dielectric grease to the inside of each spark plug cap and reinstall the caps onto the plugs. 5. Turn the engine over several times. Oil will be forced in and around the piston rings and ring lands, coating the cylinder with a protective film of fresh oil. 6. If Polaris fuel system additive is not used, fuel tank, fuel lines, and injectors should be completely drained of gasoline. Battery Maintenance Remove the battery and recharge it fully. Store the battery in a cool, dry place. Engine Anti-Freeze Test engine coolant strength and change if necessary. Coolant should be replaced every two years. Storage Area/Covers Be sure the storage area is well ventilated, and cover the machine with a genuine Polaris cover. NOTE: Do not use plastic or coated materials. They do not allow enough ventilation to prevent condensation, and may promote corrosion and oxidation. 97