2006 Infiniti G35 Owner's Manual - Page 320
2006 Infiniti G35 Manual
Page 320 highlights
VEHICLE LOADING INFORMATION Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the vinyl bag. License plate bracket J-nut x 2 Screw x 2 Screw grommet x 2 1. Temporarily place the license plate bracket and mark the pilot hole points A B k using holes k while aligning the towing hook hole of the front bumper fascia. 2. Remove the license plate bracket. A 3. Carefully drill two pilot holes k using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the fascia, or damage to the nut may occur.) 6. Insert a J-nut into the license plate bracket before placing the license plate bracket on the fascia. 7. Install the license plate bracket with screws. 8. Install the license plate with bolts that are no longer than 0.55 in (14 mm). WARNING It is extremely dangerous to ride in a cargo area inside of a vehicle. In a collision, people riding in these areas are more likely to be seriously injured or killed. Do not allow people to ride in any area of your vehicle that is not equipped with seats and seat belts. Be sure everyone in your vehicle is in a seat and using a seat belt properly. TERMS It is important to familiarize yourself with the following terms before loading your vehicle: Curb Weight (actual weight of your vehicle) - vehicle weight including: standard and optional equipment, fluids, emergency tools, and spare 4. Insert grommets into the hole on the fascia. 5. Insert a flat-blade screwdriver into the C grommet hole to turn part k 90 degrees. 9-14 Technical and consumer information