2006 Infiniti G35 Owner's Manual - Page 198

"Send/Enter/Call/Dial" - Use the Send command to enter numbers during a call. For example, if you were directed to dial an extension by an automated system: Say: "Send one two three four." The system acknowledges the command and sends the tones associated with the numbers. The system then ends the VR session and returns to the call. "Transfer call" - Use the Transfer Call command to transfer the call from the Bluetooth Hands-Free Phone System to the cellular phone when privacy is desired. The system announces, "Transfer call. Call transferred to privacy mode." The system then ends the VR session. You can also issue the Transfer Call command again to return to a handsfree call through the vehicle. "Mute" - Use the Mute command to mute your voice so the other party cannot hear it. Use the mute command again to unmute your voice. NOTE: If the other party ends the call or the cellular phone network connection is lost while the Mute feature is on, the Mute feature may need to be reset to "off." When prompted by the system, say the name you would like to give the new entry. For example, say: "Mary." If the name is too long or too short, the system tells you, then prompts you for a name again. Also, if the name sounds too much like a name already stored, the system tells you, then prompts you for a name again. Once the system accepts the name and you confirm it is correct, the system asks for a location (Home, Office, Mobile or Other). "Phone book" The Phone Book stores up to 40 names for each phone paired with the system. Each name can have up to 4 locations/phone numbers associated with it. NOTE: Each phone has its own separate phone book. You cannot access Phone A's phone book if you are currently connected with Phone B. A "New entry" k For example, say: "Home." The system acknowledges the location and asks for a number. For example, say: "five five five one two one two." See "How to say numbers" earlier in this section for more information. The system repeats the number and prompts you for the next command. When you have finished entering numbers, choose "Store." Use the New Entry command to store a new name in the system. 4-38 Display screen, heater, air conditioner and audio systems