2006 Infiniti G35 Owner's Manual - Page 158

Confirming memory storage Turn the ignition ON and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored in position, the indicator light will stay on for approximately 5 seconds. If the battery cable is disconnected, or if the fuse opens, the memory will be canceled. Reset the desired position using the previous procedure. switch (1 or 2) fully for at least 1 second. Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) fully for at least 1 second. The driver's seat and steering column will move to the memorized position with the indicator light flashing, and then the light will stay on for approximately 5 seconds. the previous function).) positions (entry/exit when the memory switch 1 or 2 is not pushed and held for at least 1 second. when the seat has already been moved to the memorized position. when no seat position is stored in the memory switch. when the parking brake is not applied. - MT models when the speed is above 4 MPH (7 km/h) while the parking brake is applied. - MT models To restart the drive positioner system, move the parking brake to off and on. when the front seat is folded for operating the walk-in mechanism (if so equipped). when the engine is started while the automatic drive positioner is operating. when the AT selector lever is moved from the P position to any other position. (However, it will not be cancelled if the switch is pushed while the seat and steering column are returning to the previous positions (entry/exit function).) SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: when the vehicle speed is above 4 MPH (7 km/h). when the adjusting switch for the driver's seat and steering column is turned on while the automatic drive positioner is operating. when the cancel switch (if so equipped) is pushed to the CANCEL side. (However, it will not be cancelled if the switch is pushed while the seat and steering column are returning to Selecting the memorized position 1. For vehicles equipped with automatic transmission, move the selector lever to the P (Park) position. For vehicles equipped with manual transmission, move the shift lever in the N (Neutral) position and apply the parking brake. 2. Use one of the following methods to move the driver's seat and the steering wheel. Turn the ignition switch to the "ON" position and push the memory 3-36 Pre-driving checks and adjustments