Zanussi ZDF26004XA User Manual - Page 7
Deactivating The Rinse Aid Empty
View all Zanussi ZDF26004XA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
CANCEL FUNCTION Use CANCEL to: • CANCEL the currently running programme. • Stop the countdown of the Delay option. • Bring the appliance back to the programme selection mode. To CANCEL, press and hold and until the appliance is in programme selection mode. USER MODE User mode allows to change the following settings: • Adjust the level of the water softener according to the water hardness. • Activate or deactivate the rinse aid empty notification. • Activate or deactivate AirDry. Before entering user mode, make sure the appliance is in programme selection mode: 1. Press and hold and . • The indicators , and flash. As the appliance stores the saved settings, there is no need to configure it before every cycle. THE WATER HARDNESS TABLE ADJUSTING THE WATER SOFTENER Make sure that the appliance is in user mode: 1. Press . • The indicators and are off. • The indicator still flashes. • The display shows the current setting: e.g. = level 5. 2. Press to change the setting. Each pressing increases the level number by one. After reaching level 10, the countdown starts again from level 1. 3. Press on/off to confirm the setting. If you use multi-tabs containing salt and the hardness of your water is lower than 21°dH, you can set the lowest water softener level. It deactivates the salt refill indicator. If you use standard detergent or multitabs without salt, set the proper water hardness level to keep the salt refill indicator active. German degrees French degrees (°dH) (°fH) mmol/l Clarke degrees Water softener level 47 -50 43 - 46 37 - 42 29 - 36 23 - 28 19 - 22 84 - 90 76 - 83 65 - 75 51 - 64 40 - 50 33 - 39 15 - 18 11 - 14 4 - 10