TASCAM MX CONNECT wner s Manual - Page 23
Information display on the RC-W100, Source settings
View all TASCAM MX CONNECT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
2 - TASCAM MX CONNECT 0 Source settings Use to select the input sources controlled by the RC-W100. Tap these fields to open option lists. When MODE is set to MODE 1, a maximum of 4 sources can be set. When MODE is set to MODE 2, a maximum of 8 sources can be set. NOTE If no sources have been set, the source selection function will be disabled. Information display on the RC-W100 When the source selection function is enabled, the name of the current input source will be shown on the RC-W100 display. The INPUT name set on the Additional Input Settings screen will be used for the input source name. (see "2 Input Name setting field" on page 11) Only the following characters can be shown. 0123456789 ABCDEFGHIJKLMNOPQRSTUVWXYZ abcdefghijklmnopqrstuvwxyz Single-character space pp If characters other than these are used, they cannot be shown properly. pp A maximum of 8 characters can be shown on the RC-W100. pp Characters after the first 8 will not be shown on the RC-W100. TASCAM MX CONNECT 23