TASCAM MX CONNECT wner s Manual - Page 18

2 - TASCAM MX CONNECT Additional Output Settings screen NOTE Level meter movement might be delayed or stop depending on the network setup and Wi-Fi connection conditions. 1 Output channel This shows the channel number for the open Additional Output Settings screen. Tap g or t to open the Additional Output Settings screen for an adjacent channel. 2 Output Name setting field Set the output name to be shown on the OUTPUT page. Tap this area to make the cursor blink, enabling character input. Up to 96 English letters and numbers can be input. 3 6 button Close the Additional Output Settings screen and return to the Output page. 4 Test tone on/off button This turns the test tone on/off. When on, the button lights and the TEST TONE setting screen opens. NOTE When the test tone is on, it will be output instead of the signal set on the ROUTING page. 5 MIX master level meter This shows the signal level of the MIX master fader as a decibel value and with a level meter. NOTE When the test tone is on, the mix master level and meter are disabled. 6 EQUALIZER/DELAY window Tap a tab to open the corresponding window. 7 Fader level This shows the level of the output channel fader below it as a decibel value. Range: - inf, -126.9 dB - +10 dB (0.0 dB default, 0.1 dB intervals) The channel fader send level can be set by tapping here and entering it with a keyboard. 8 Output channel fader Use this to adjust the level of the output channel signal sent to the output jack. Drag the output channel fader up or down to adjust the output level. Tap the 5 and b buttons to adjust in 0.1 dB intervals. The gain value of the output channel fader is shown in the fader level display area (7). NOTE Double-tap the fader to set it to 0 dB. 9 LIMITER button Press this button to turn the limiter function ON/OFF. When the limiter function is on, the button appears lit. 0 THRESHOLD setting status Set the threshold level, which is the level when the limiter starts operating. Settings: -54 dB - 0 dB (0 dB default, 1 dB increments) To set this, use keyboard input in the setting level display area, the slider, or the 5 and b buttons. q Output channel level meter This shows the signal level of the output channel as a decibel value and with a level meter. w LIMITER indicator When the LIMITER function is affecting the signal, the indicator lights red. e Mute button Tap the button to mute that channel. The button appears unlit when muted. (Default: lit) Tap the button to unmute that channel. r GROUP button Tapping a GROUP button will open a GROUP pop-up menu. Tap a GROUP number button to select it and close the pop-up. That button will now appear. Button Meaning This removes any group assignment (default). This links the faders and mute buttons of channels in the same group. NOTE ii All channels can be grouped at the same time. ii If the MX-8A unit firmware version is 1.02 or earlier, or the TASCAM MX CONNECT version is 1.1.0 or earlier, the GROUP buttons will only turn grouping on/off. t PHASE button Use this to change the phase of the signal on the output channel. Tap this button to reverse the phase of the output channel. Normal Reversed TASCAM MX CONNECT 18