Sub-Zero BI-36S Built-In Use & Care Guide - Page 23

Built-In Use & Care 23 subzero.com Ice and Water Dispenser EXTERNAL DISPENSER MODELS For external dispenser models BI-42SD and BI-48SD, the ice and water dispenser in the refrigerator door gives you both ice and chilled water without having to open the door. IMPORTANT NOTE: Make sure the dispenser key pads are clean and dry to avoid problems with dispenser operation. The water tank holds approximately 50 oz (1.5 L) of filtered, chilled water. After the tank has been filled for the first time or if all 50 oz (1.5 L) have been dispensed at one time, drops of water may collect in the removable water grille which is located at the bottom of the glasswell. Because there is no drain in this area, do not pour water into the water grille. To operate the external dispenser, set a glass on the water grille of the glasswell. For ice, press and hold the ICE key pad on the glasswell until you have the ice you need. For water, press and hold the WATER key pad until the glass is filled. Refer to the illustration below. Models BI-42SD and BI-48SD have a feature that limits the maximum amount of ice that is dispensed each time the ICE key pad on the glasswell is pressed. For metered ice, hold the ICE key pad for approximately two seconds. The dispenser will meter out ice for about two seconds, collect the ice directly above the glass, then drop the ice into the glass. If less ice is desired, hold the ICE key pad for less than two seconds. For more ice, hold the ICE key pad until the dispensing cycle repeats. LOCK INDICATOR ICE WATER LIGHT WATER GRILLE BEZEL BULK ICE KEY PAD For larger quantities of ice, open the refrigerator door and place an ice container under the dispenser chute located on the left interior wall of the refrigerator section. Press the BULK ICE key pad on the dispenser until you have the ice you need. Refer to the illustration. Limit continuous ice and water dispenser operation to seven minutes or less, to avoid damage to the unit. DISPENSER LIGHT For models BI-42SD and BI-48SD, there are three lighting states that can be cycled by pressing the LIGHT key pad on the glasswell; all lights OFF, all lights ON (blue key pad and white glasswell) and key pad lights ON only. During water or ice dispensing, all lights will illuminate until dispensing is complete, then lights will return to their previous state. DISPENSER LOCK For models BI-42SD and BI-48SD, the lock feature is used to prevent unintended ice and water dispensing. When the dispenser is locked, all key pads on the glasswell are deactivated to allow for cleaning or to prevent small children from using the dispenser. To activate the lock feature, hold the LIGHT key pad on the glasswell until the key pad lights flash once and the red LOCK icon is illuminated (approx five seconds). The lights will remain in the state they were in before the lock feature was activated. To deactivate the lock feature, hold the LIGHT key pad until the key pad lights flash once and the red LOCK icon is no longer illuminated (approx five seconds). The lights will remain in the state they were in before the lock feature was deactivated. External dispenser glasswell. Bulk ice dispenser.