Stihl HT 102 Product Instruction Manual - Page 17
Cutting Attachment, Mounting the Bar and Chain
![]() |
View all Stihl HT 102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Cutting Attachment Chain scabbard English Mounting the Bar and Chain 246BA021 KN A cutting attachment consists of the saw chain, guide bar and chain sprocket. The cutting attachment that comes standard is designed to exactly match the pole pruner. Removing the Chain Sprocket Cover 001BA244 KN 1 2 a 3 - The pitch (t) of the saw chain (1), chain sprocket and the nose sprocket of the Rollomatic guide bar must match. - The drive link gauge (2) of the saw chain (1) must match the groove width of the guide bar (3). If non-matching components are used, the cutting attachment may be damaged beyond repair after a short period of operation. 001BA248 KN Your pole pruner comes standard with a chain scabbard that matches the cutting attachment. If you use guide bars of different lenghts on the pole pruner, the length of the chain scabbard must be matched to the guide bar to reduce the risk of injury. It should cover the full length of the guide bar. The length of the matching guide bars is marked on the side of the chain scabbard. N Unscrew the nut and remove the chain sprocket cover. 1 2 N Turn the screw (1) clockwise until the tensioner slide (2) butts against the right end of the housing slot. 246BA022-A1 HT 102, HT 103, HT 132, HT 133 15
![](/manual_guide/products/stihl-ht-102-product-instruction-manual-f9ab27b/17.png)