Sharp MX-M4071 User Manual - Page 783

SETTING MODE►SYSTEM SETTINGS Network Settings Quick Settings Select the minimum required settings for the machine connection to the network. Wireless Settings On the MX-M2651/MX-M3051/MX-M3551/MX-M4051/MX-M5051/MX-M6051,this setting appears when a wireless LAN adaptor is installed. Connection Type Use this setting to switch between [Wired Only], [Wired+Wireless (Access Point Mode)] or [Wireless (Infrastructure Mode)]. Keep Wireless Access Point activated This can only be enabled when "Connection Type" is "Wired+Wireless (Access Point Mode)". If disabled, the NFC touch point area (on the MX-M3071/MX-M3571/MX-M4071/MX-M5071/MX-M6071) or the NFC card reader (on the MX-M2651/MX-M3051/MX-M3551/MX-M4051/MX-M5051/MX-M6051) must be touched to the mobile device or the [Easy Connect (QR code)] key must be tapped in the home screen to enable wireless LAN. When one of the conditions below occurs, the wireless LAN connection is automatically canceled. • When there is no connection to the access point for a certain period of time. When "Wireless (Infrastructure Mode)" is selected in "Connection Type" Access Point Search Click this to search access points. When the search results are displayed, select the access point to use and click [OK]. [SSID], [Security Type], and [Encry.] are automatically applied. SSID Enter an SSID using up to 32 characters. Security Type Select a security type. Encry. Select an encryption type. Security Key Enter a security key. Security Type Security Key • WEP • WPA/WPA2-mixed Personal • WPA/WPA2-mixed Enterprise • WPA2 Personal • WPA2 Enterprise WEP64bit: 5 characters or 10-digit hexadecimal number WEP128bit: 13 characters or 26-digit hexadecimal number WPA/WPA2: 8 to 63 characters or 64-digit hexadecimal number Show Security Key If it is set to ON, the security key appears. IPv4 Settings When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine. DHCP Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is not necessary to manually enter an IP address. If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing will not be possible. 7-86