Sharp BP-50M45 Operating Manual - Page 991

TROUBLESHOOTING►GENERAL PROBLEMS Check Has the tray been prohibited in some modes (copy, print, fax, image send, document filing)?  Solution ■ Check the settings in [Paper Tray Settings] and see if checkmarks appear in the checkboxes of each mode ([Feeding Approved Job]). Functions without a checkmark cannot be used for printing using that tray.  "Settings" → [System Settings] → [Common Settings] → [Paper Settings] → [Paper Tray Settings] → [Tray Registration] → [Feeding Approved Job] I DON'T KNOW HOW TO CHANGE THE PAPER SIZE Check Set the paper size used in each tray in the tray settings.  Solution ■ The "Tray Settings" key can be found in the home screen. Tap this key to display the tray settings screen. Tap the tray whose paper size you want to change, select the paper type, and then tap the [Size] tab. Select the paper size and tap the [OK] key. If you loaded a special size of paper in the bypass tray, tap the [Direct Entry] key after tapping the [Size] tab, enter the paper size manually, and tap the [Execute] key. THE OUTPUT IS NOTICEABLY CURLED AND UNEVEN Check Remove the paper, turn it over, and reload it. Using a different paper type may solve the problem.  Solution ■ This may improve some states of paper curling. ► LOADING PAPER (page 1-11) THE IMAGE IS SKEWED ON THE PAPER Check  Solution Is too much paper loaded into the bypass tray? Are the bypass tray guides adjusted to the width of the paper? Are the original guides adjusted to the width of the paper? ■ Reload the paper. Load no more than the maximum number of sheets and do not exceed the indicator line. The maximum number of sheets varies depending on the paper type setting. ■ Adjust the bypass tray guides to the width of the paper so that they slightly contact the sides of the paper. ■ Adjust the original guides to the width of the paper. 10-12