Sharp BP-50M45 Operating Manual - Page 921
IPv4 Settings, Network Name Settings, DNS Settings
![]() |
View all Sharp BP-50M45 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 921 highlights
SETTING MODE►SYSTEM SETTINGS Show Security Key If it is set to ON, the security key appears. Factory default settings:No Sound IPv4 Settings When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine. The settings are shown below. DHCP Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is not necessary to manually enter an IP address. Factory default settings: Enable If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing will not be possible. IPv4 Address Enter the IP address of the machine. Subnet Mask Enter the IP subnet mask. Default Gateway Enter the default gateway address. Network Name Settings Device Name Enter a device name. Domain Name Enter the domain name. Factory default settings: Sharp-Printer DNS Settings Primary Server Enter the IP address of primary DNS server. Secondary Server Enter the IP address of secondary DNS server. Domain Name Enter the domain name where the selected DNS server exists. 9-155
![](/manual_guide/products/sharp-bp50m26-operating-manual-4b37c5b/921.png)