Rane MP2015 Owners Manual - Page 15

DJ Changeover

Page 15 highlights

DJ Changeover One of the biggest challenges of digital DJing has been seamlessly changing over from one DJ to the next and playing back-to-back DJ sets. With the dual USB architecture of the MP2015 mixer, changeover between digital DJs has never been easier. Deck Changeover Controls PH/CD 1 AUX 1A 1B PH/CD 2 AUX 2A 2B PH/CD 3 AUX 3A 3B PH/CD 4 AUX 4A 4B At the top of each input channel is the Source Selector to switch input sources. If your computer is connected to USB port A, switch a channel Source Select knob to SOURCE I SUB SOURCE II SUB SOURCE III SUB SOURCE IV SUB USB A, and the mixer assigns the corresponding virtual deck to that channel for audio playback. For example, assigning all four channels to USB 1A-4A assigns all four virtual decks to the computer connected to USB port A. The same applies to USB port B. If your computer is connected to USB port B, switching a channel Source Select knob to USB B, assigns the corresponding virtual deck to that channel for audio playback. When two DJs are connected to the MP2015, they can quickly swap deck control between computers using the Source Select knobs. Any of the four inputs can be swapped back and forth with a simple knob twist. Nice and easy, just the way we intended. The DJ Changeover Walkthrough In the scenario below, one DJ, let's call him DJ A, is already connected to the MP2015 using either USB port A or B. With DJ A's computer already connected and playing music, do the following: 1. Connect your computer to the unused USB port on the MP2015. 2. Switch the Input Source on a non-playing input channel to the USB source of your computer. 3. Play a track on this Deck and mix it in when you're ready - audio from both computers are in the mix. 4. Fade out the audio playing from DJ A's computer to the audio playing from your computer. 5. Assign the Input Source for the remaining free mixer channel(s) to your computer and continue DJing. When DJ A is done, disconnect his computer from the USB port. If you're back-to-back mixing with DJ A, keep the computer connected and perform the same swapping instructions to regain deck control. USB MIC USB TURNTABLE OUT CD OUT 0 dB 0 dB 0 dB ∞ +10 LOW 225 135 380 80 640 CROSSOVER ∞ +10 MID 2.8k 1.7k 4.75k 1.0k 8.0k CROSSOVER ∞ +10 HIGH ISO ACTIVE PH/CD 1 AUX 1A 1B PH/CD 2 AUX 2A 2B PH/CD 3 AUX 3A 3B PH/CD 4 AUX 4A 4B SOURCE I 456 3 7 SUB 2 8 1 9 0 10 GAIN | SOURCE II SUB 456 3 7 2 8 1 9 0 10 GAIN | SOURCE III SUB 456 3 7 2 8 1 9 0 10 GAIN | SOURCE IV SUB 456 3 7 2 8 1 9 0 10 GAIN | OL OL OL OL +10 +10 +10 +10 OFF +6 +7 OFF +6 +7 OFF +6 +7 OFF +6 +7 HIGH +5 HIGH +5 HIGH +5 HIGH +5 +3 +3 +3 +3 | | | | +2 +2 +2 +2 +1 +1 +1 +1 0 0 0 0 -1 -1 -1 -1 OFF +6 -2 OFF +6 -2 OFF +6 -2 OFF +6 -2 MID -3 MID -3 MID -3 MID -3 -5 -5 -5 -5 | | | | -7 -7 -7 -7 -10 -10 -10 -10 -15 -15 -15 -15 -24 -24 -24 -24 OFF +6 LOW OFF +6 LOW OFF +6 LOW OFF +6 LOW LEFT RIGHT OL +10 +7 +5 +3 +2 +1 0 -1 -2 -3 -5 -7 -10 -15 -24 5 4 6 3 7 2 8 1 9 0 10 MAIN 456 3 7 2 8 1 9 0 10 BOOTH MAIN FX LOOP SUB FX ON DRY WET AUX 4 5 6 SUB 3 7 2 8 1 9 0 10 SESSION IN | OFF +6 HIGH | OFF +6 MID | OFF +6 LOW 456 3 7 OL 2 8 +10 1 9 +7 0 10 SESSION OUT +5 +3 +2 MIC +1 OFF 4 5 6 DUCK 0 3 7 -1 2 8 -2 1 9 -3 0 10 GAIN -5 -7 -10 -15 -24 BASS TREBLE TONE FILTER FILTER FILTER FILTER 5 4 6 3 7 2 8 1 9 0 10 MIX CUE I 5 4 6 3 7 2 8 1 9 0 10 MIX CUE II 5 4 6 3 7 2 8 1 0 MIX 9 10 CUE III 5 4 6 3 7 2 8 1 0 MIX 9 10 CUE IV LOW HIGH RESONANCE SPLIT FILTER 5 4 6 3 7 2 8 1 0 MIX 9 10 CUE SUBMIX CUE MIX PAN 456 3 7 2 8 1 9 0 10 LEVEL PHONES MP2015 MANUAL TURNTABLE OUT CD OUT 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

15
MP2015 MANUAL
DJ Changeover
One of the biggest challenges of digital DJing has been seamlessly changing over from one DJ to the next and playing
back-to-back DJ sets. With the dual USB architecture of the MP2015 mixer, changeover between digital DJs has never
been easier.
Deck Changeover Controls
At the top of each input channel is the Source Selector
to switch input sources. If your computer is connected
to USB port A, switch a channel Source Select knob to
USB A, and the mixer assigns the corresponding virtual deck to that channel for audio playback. For example, assigning all
four channels to USB 1A-4A assigns all four virtual decks to the computer connected to USB port A.
The same applies to USB port B. If your computer is connected to USB port B, switching a channel Source Select knob
to USB B, assigns the corresponding virtual deck to that channel for audio playback.
When two DJs are connected to the MP2015, they can quickly swap deck control between computers using the Source
Select knobs. Any of the four inputs can be swapped back and forth with a simple knob twist. Nice and easy, just the way
we intended.
The DJ Changeover Walkthrough
In the scenario below, one DJ, let’s call him DJ A, is already connected to the MP2015 using either USB port A or B. With
DJ A’s computer already connected and playing music, do the following:
1. Connect your computer to the unused USB port on the MP2015.
2. Switch the Input Source on a non-playing input channel to the USB source of your computer.
3. Play a track on this Deck and mix it in when you're ready — audio from both computers are in the mix.
4. Fade out the audio playing from DJ A’s computer to the audio playing from your computer.
5. Assign the Input Source for the remaining free mixer channel(s) to your computer and continue DJing.
When DJ A is done, disconnect his computer from the USB port. If you’re back-to-back mixing with DJ A, keep the
computer connected and perform the same swapping instructions to regain deck control.
I
II
III
IV
SUB
SUB
SUB
SUB
SOURCE
SOURCE
SOURCE
SOURCE
1B
1A
PH/CD 1
AUX
2B
2A
PH/CD 2
AUX
3B
3A
PH/CD 3
AUX
4B
4A
PH/CD 4
AUX
TURNTABLE OUT
MIC
TURNTABLE OUT
CD OUT
CD OUT
USB
USB
I
II
III
IV
I
II
III
IV
SUBMIX
MAIN
MIC
PHONES
LOW
MID
HIGH
ISO