Pioneer VSX-LX303 Instruction Manual English - Page 85
To set the function to off
View all Pioneer VSX-LX303 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Playing Back Contents ≫ Connections ≫ Playback ≫ Setup ≫ Set the remote controller to the ZONE control mode (ZONE 2/ZONE 3) ( p83, 84), and then perform the following operations. 1. Point the remote controller at the unit, and press . • "Z2" or "Z3" on the display of the main unit lights up. • ZONE 3 cannot be turned ON unless "Speaker" - "Configuration" - "Zone Speaker" in the System Setup menu ( p105) is not set to "Zone 2/Zone 3". 2. Press the input selector of the input source you want to play in the separate room. When operating on the main unit, press the ZONE CONTROL button repeatedly to select "Z2" or "Z3", and select the input to playback in other room with the input selector dial within 8 seconds. 3. To adjust the volume on the power amplifier in the separate room or the ZONE speaker, adjust with VOL+/- on the remote controller. When operating on the main unit, press the ZONE CONTROL button repeatedly to select "Z2" or "Z3", and adjust with the MASTER VOLUME dial within 8 seconds. • If you turn the unit to standby during multi-zone playback, the Z2 or Z3 indicator is dimmed, and the playback mode is switched to playback in a separate room only. Setting ZONE 2/ZONE 3 to on while the unit is in standby also switches the playback mode to playback in a separate room only. • For ZONE 2 output, audio from externally connected AV components can be output only when it is an analog or 2ch PCM audio signal. When the AV component is connected to this unit with a digital coaxial cable or digital optical cable, change the audio output of the AV component to the PCM output. • For ZONE 3 output, audio from externally connected AV components can be output only when it is an analog audio signal. • DSD and Dolby TrueHD audio signals cannot be output to ZONE 2/ZONE 3 when selected with the "NET" or "USB" input selector. • If ZONE 2/ZONE 3 is on, power consumption during standby will increase. To set the function to off: Press while the remote controller is in the ZONE control mode. When operating on the main unit, press the ZONE 2 ON/OFF or ZONE 3 ON/OFF button. 85 Front Panel≫ Rear Panel≫ Remote≫